First remove the bumper cover. You need to take off the front grill to get at the plastic retainers that hold the top of the buimber on. There are about four retainers on the bootom of the bumper.
Unscrew it.
it is under front bumper on drivers side...this is on a 1997 expedition 4x4
Not sure about the 97 but the 98 is right behind the front bumper on the driver side. You have to kinda pull the wheel well plastic back A little and you will see it in there. hope this helps!
The 1997 Pontiac Sunfire front bumper is held in place by six retaining clips and for retaining bolts. Remove the retaining bolts and pry outward on each retaining clip.
To remove the bumper support from a 1997 Nissan Altima, first, lift the front of the vehicle and secure it on jack stands for safety. Remove the screws or bolts securing the bumper cover, typically found in the wheel wells and under the front of the vehicle. Once the bumper cover is off, locate the bolts holding the bumper support to the frame and remove them using a socket wrench. Finally, gently pull the support away from the vehicle.
Remove the grillyes you have to remove the grill to change the headlights. Remove the 2 turn sig. screws on each side, and realease (6) plastic clips on the top of the grill and (5) clips on the bottom of the grill just above the bumper.
Yes, to fit a towbar on a 1997 Saab convertible, you typically need to remove the rear bumper. This is necessary to access the mounting points and ensure proper installation of the towbar. After installation, the bumper is usually reattached to maintain the vehicle's aesthetic and structural integrity. Always consult the specific towbar installation instructions for your model for the best results.
To remove the rear speakers on a 1997 Cadillac Sedan Deville, first remove the two screws under the plastic covers surrounding the rear speakers. Lift the plastic covering and the speakers should come off.
There lots of things that need to be remove. If your not sure or dont know on how to take this task on. Take it too the shop.
well i had to pull my front bumper off to put the headlights on. I have a 1997 prelude so i don't know what year you have but i would guess the front bumper will have to come off.
how to reset the computer on a 1997 ford expedition