0
Upper pulley - remove nut on generator shaft. The nut, bell-shaped washer, extra shims, pulley half, used shims, and inner pulley half come off in that order. More shims between the pulley halves will loosen the belt. Fewer shims will tighten it. Put the leftover shims under the bell shaped washer so they'll be around when you put on a new, tight belt.
Lower pulley - Put the car in 4th gear and remove the bolt (it's right handed) If the pulley is really stuck, you might need a gear puller to get it off.
What else can I help you with?
Remove a crank pulley from a 1974 vw beetle?
Impact gun/wrench and a puller
How do you remove front seat pully for VW Polo?
To remove the front seat pulley from a VW Polo, first, ensure the vehicle is turned off and the battery is disconnected for safety. Next, locate the pulley, which is typically attached to the seat frame. Use the appropriate tools, usually a socket set, to remove the bolts or screws securing the pulley in place. Once detached, carefully pull the pulley away from the seat assembly.
Will a 1971 vw bug type a transmission fit into a 1969 vw bug type a?
yes
Will a 1969 vw bug hood fit a 1971 vw bug?
If the 71 is a standard then yes it will fit.
How do you open gas lid on a 1972 vw bug?
how do i get into a trunk o f a vw bug 1972
How do you remove BUG VW ignition switch 1966?
Just remove one screw inside car, under the dashboard near the ignifion switch area.
How remove a 1978 vw bug seat?
To remove a 1978 VW Bug seat, start by sliding the seat all the way forward to access the bolts at the rear. Use a socket wrench to remove the two bolts holding the rear of the seat in place. Once the rear bolts are out, slide the seat back to access and remove the front bolts. Finally, lift the seat out of the vehicle carefully.
What is the length of 1969 VW beetle?
length of 1969 vw bug
Will 66 vw fenders bolt on a 68 vw bug?
Yes
Where is the new bug made the 2012 vw bug what country?
MEXICO
Will a 1966 VW Bug front fender fit on a 1969 Bug?
no.
How do you remove front seats in a 1967 vw bug?
To remove the front seats in a 1967 VW Bug, start by locating the two bolts on each seat rail, which are typically covered by plastic caps. Use a socket wrench to remove these bolts. Once the bolts are out, gently pull the seat forward to detach it from the rear clips, and lift it out of the car. Repeat the process for the other seat.
