I believe the brake light switch is at the base of the brake pedal. However, it takes a special tool usually to remove and replace it. It is a cheap part, easy labor, and worth the payment to a professional if they will do it for under $20.00 or so. You can strand yourself if you can't get the replacement on correctly. Mary
brake light switch is mounted by the brake pedel remove lower panel above brake pedel and then you will see the switch should be able to turn the switch to replace
DOT 3
look at the fluid reseviour.. if the fluid is low.. tis time to replace the brake pads.. as the pads wear out the fluid level drops
check and/or replace brake pedal switch.
It plugs into the taillight.
Under the hood, driver side.
Switch on brake pedal needs tightened replaced, or switch for lights needs tightened or replaced.
To change the rear brakes on a 1992 Chrysler LeBaron convertible, first, lift the rear of the vehicle and secure it on jack stands. Remove the wheel and then the brake caliper by unbolting it, allowing it to hang (do not disconnect the brake line). Replace the brake pads and, if necessary, the rotors, then reassemble by reversing the disassembly steps. Finally, pump the brake pedal to ensure proper brake function before lowering the vehicle.
Its located on the brake pedal. Unplug the wiring harness and unbolt it and replace it.
back wheels.
The brake light switch is above the pedal.
On the bracket the brake pedal mounts to.