To remove the headlight lens cover on a 1992 Subaru Legacy for cleaning, first, ensure the car is turned off and the headlights are cool. Use a flat-head screwdriver or a trim removal tool to gently pry off the plastic clips or screws securing the lens cover. Once the clips are removed, carefully pull the lens cover away from the headlight assembly. Clean the interior surface of the lens as needed before reattaching it securely.
Remove the 2 screws that hold the plastic lens, pull out burned bulb, push in new one (#168 or #194), verify if working, reinstall lens.....
The headlights are sealed units, unfortunately they do cloud over a bit with age. Try a cut and polish on the outside of the lens to clean them up a bit, but you would have to go to a plastic welder or similar to get them to remove the housing, and even then, cleaning them may not remove the cloudy effect.
how to replace the headlight
Unscrew the lens, replace the bulb, and put the lens back on.
If you mean the 3rd brake light, it has a couple of screws to be removed to get the cover off allowing access to the bulb. If you're talking about the multifunction (brake/signal/parking) lights, it's similar. You'll have to remove the whole lens assembly. Be careful with it, cause you don't want to damage that lens assembly, they're ridiculously expensive to replace.
If you are speaking about replacing the bulb - just inside the tailgate, on either side there are little "doors" set into the decorating panel. Open them to gain access to the rear of the lens housing so that you can remove the bulb from the rear of the housing to replace it.
You should be able to purchase a CCTV security lens where your friend purchased the security camera. Supposedly it is relatively easy to replace by the camera lens yourself.
I assume you mean HEADLIGHT LENS.. .. there are 3 bolts on the back, remove, pull out headlight. Remove clips and broken lens. Replace gasket, lens and put on clips FRONT TO BACK so you don't chip the lens. Reinstall with 3 bolts on back.
To replace the lens in Oakley Minutes sunglasses, first open the nose bridge and gently push the lens out from the top corner. Then, align the new lens with the grooves on the frame and push it into place. Ensure the lens is securely in place before closing the nose bridge.
eBay has plenty. two screws holding lens in.
Remove the dome light lens, pull the old bulb out, and replace with new bulb; replace the lens.