To replace the rear engine seal on a Honda, first ensure the vehicle is safely lifted and secured. Remove the transmission or transaxle to access the rear of the engine, then carefully extract the old seal using a seal puller or flat tool. Clean the sealing surface and install the new seal, ensuring it is seated evenly. Finally, reassemble the transmission and check for leaks after starting the engine.
yes
You must remove the transmission are engine to replace the rear main seal.
That engine has a solid round one piece rear main seal that slides over the rear of the crankshaft. You will either have to remove the engine are transmission to be able to replace the rear seal. No other way to do it. ( BIG JOB ) and a good paying job.
You will have to replace the rear main seal. This will require that the transmission be removed.
Buy New 2009 civic Hehe
Oh, a lot; 4 figures. You have to completely break the engine down to replace a rear main seal.
No you can access the rear main seal by removing the Transmission, flywheel etc
Front seal: remove engine or transmission and replace the seal. Rear seal, remove the drive shaft to replace the seal. Unfortunately, you typically only have problems with the front seal.
Pull the engine.
To replace the rear main seal in a Cadillac SRX, first, you need to disconnect the battery and drain the engine oil. Next, remove the transmission by unbolting it from the engine and lowering it carefully. Once the transmission is out, you can access the rear main seal, which can be pried out with a seal puller. Install the new seal, ensuring it is properly seated, then reassemble the transmission and refill the engine oil before reconnecting the battery.
You can either pull the engine out or remove the transmission and flywheel to install the rear seal. It slides over the back of the CRANKSHAFT on the back of the engine. Must remove 1 or the other to replace seal.
You will need to remove the transmission.