To replace the bulb on your Kodascope Eight-33 projector, first ensure the projector is unplugged for safety. Open the projector cover to access the lamp compartment, typically located at the back or side. Carefully remove the old bulb by unscrewing or unclipping it, then insert the new bulb, making sure it's securely in place. Finally, close the compartment and plug the projector back in before testing the new bulb.
Remove the screws from the lens covering the bulb, pull out the bulb and replace it.
Remove the plastic housing with small slotted screwdriver. Gently remove the bulb vertically and replace with new bulb. Replace plastic housing until you hear it click into place
Remove the socket from the rear of the fixture, remove faulty bulb from socket and replace with good bulb and replace socket in fixture. Fini!
i am guessing that you want to change the bulb and not the assembly. to remove the bulb just turn it to the left remove the old bulb replace in the assembly but this time turn it to the right.
Remove screws, remove light assembly, rotate bulb holder counterclockwise & pull out, replace bulb(# 194). Installation is reverse.....
open trunk, remove replastic trim/bulb holder, r/r (remove/replace) blown bulb See sources and related links below for bulb information.
Remove the dome light lens, pull the old bulb out, and replace with new bulb; replace the lens.
If it is a front bulb, sometimes you can get to the bulb and remove it by turning it counterclockwise. If it is the rear you have to remove the housing and then remove the bulb. Remove the (4) 7mm Hex screws that fasten the wheel well liner. Pull the liner back as needed. Then reach in and remove the bulb by twisting the connector to release the connector and bulb from the turn signal housing. Pull the connector back towards you and replace the bulb.
To replace a side marker bulb on a Honda CR-V, open the hood and remove the small screw on the back of the bulb. Pull the bulb forward and it will come out easily. Replace the bulb.
remove bulb from in side the boot
Replace the burned out bulb
remove two screws, remove tail light, remove bulb. reinstallation is the reverse of removal.