Remove screws, remove light assembly, rotate bulb holder counterclockwise & pull out, replace bulb(# 194). Installation is reverse.....
As per the instructions on page 5-55 of your "Owner's Manual"...
http://www.topix.com/forum/autos/chevrolet-impala/T4P2NGT979PJ7QT2P
Time to change your oil in your engine!
Add brake fluid
how do you replace license pate light on 2006 pontia g6
It requires a scanner to properly diagnosis a check engine light.
There is one screw that holds the fog light it into place.Unscrew that screw and the fog light will pull out of the bumper.
-open trunk, there are about 7-9 plastic wing nuts holding the panel on remove them and panel pulls off. twist the bulb retainer out, replace bulb and replace retainer remount panel. easy
The most likely cause is the turn signal flasher.
Unscrew license plate and remove to expose light fixtures. Wedge light module away from holes. Replace them and return them to sockets.
u cant
Reach under the truck bumper and you should feel the backside of the license plate light unit. Give it a small turn and pull the unit out. Then pull out the bulb and replace with the new bulb and return the unit back to original location.