0
What else can I help you with?
How do you Replace starter in 1988 Corvette?
You should begin by removing the positive cable from your 1988 Chevy Corvette battery. Remove the cables from the front of the starter. Remove the three starter retaining bolts. Reverse the process to install the new starter.
How do you fix leaking windows - top corners of a 1988 RX7 Convertible?
Replace the convertible door seal.
Can a 1988 Corvette convertible be converted into a t top Corvette?
Anything can be done to any car, at any time. However, you are looking at some serious fiberglass work.
Where is the mass air power burnoff relay on a 1988 corvette?
right behind the battery,the inside one
How fast does a 1988 Corvette go?
A CORVETTE 1988 goes up to about 180
How do you change the third brake light on a 1988 Corvette convertible?
remove the license plate and reach up through that opening. Corvettes weren't designed to be easy to work on.
How do I find the end of the battery cable on a 1988 corvette?
Look under pass side by flywheel. it is probably on starter (if pos)
Where is the blower motor resistor located on a 1988 corvette?
On a 1988 Corvette, the blower motor resistor is typically located on the passenger side of the vehicle, behind the dashboard. To access it, you may need to remove the glove compartment and some additional panels. The resistor is mounted to the HVAC housing, often near the blower motor itself. Make sure to disconnect the battery before attempting to replace it.
Replace thermostat on 1988 Corvette?
Drain the water from your 1988 Chevy Corvette cooling system. Remove the water supply hose from the top of your thermostat housing. Remove the thermostat housing bolts. Remove the thermostat. Reverse the process to install the new thermostat.
Is there airbags in a 1988 Corvette?
NO.
Can 1988 Corvette door panels fit a 1986 Corvette?
yes.
Where is the hydraulic reservoir for 1988 Chrysler lebaron convertible top?
Where is the hydraulic reservoir for 1988 Chysler Lebaron convertible top?
