To replace the distributor on a 1997 5.7L engine, first disconnect the battery and remove any components obstructing access to the distributor. Mark the position of the existing distributor and the rotor's orientation for proper alignment during reinstallation. Remove the distributor hold-down bolt, lift the distributor out, and install the new distributor in the same orientation, ensuring it aligns with the marks you made. Finally, reattach any disconnected components, reconnect the battery, and check the ignition timing if necessary.
SORRY, But it don't have a timing belt. It has timing chain and gears.
To remove and replace the distributor on a 1997 5.7 Vortec engine, first disconnect the battery and remove the ignition coil and any wiring connected to the distributor. Mark the position of the distributor housing and rotor for proper alignment during reinstallation. Remove the distributor hold-down bolt and carefully lift the distributor out, noting the orientation of the gear. Install the new distributor by aligning it with the marked position, securing it with the hold-down bolt, and reconnecting all wiring and the ignition coil.
To replace the distributor on a 1997 Mazda 626 2.0 automatic, first disconnect the negative battery terminal to ensure safety. Remove the ignition wires from the distributor cap, then detach the cap itself. Unscrew the distributor from the engine block, noting the alignment for reinstallation, and carefully pull it out. Install the new distributor by reversing the process, ensuring the timing aligns correctly before reconnecting the battery.
You have to replace the distributor assembly.You have to replace the distributor assembly.
the cyp sensor is located inside of your distributor....you'll need to replace your distribtor
To replace the distributor on a 1997 Ford Laser Tracer with an F6 engine, first, disconnect the battery and remove any components obstructing access to the distributor. Mark the position of the old distributor and the ignition wires for proper reinstallation. Remove the retaining bolts, lift the old distributor out, and install the new one in the same position. Reconnect the ignition wires, reassemble any removed components, and reconnect the battery to complete the process.
Ignition control module.. located under the distributor The distributor cap is probably cracked and moisture is getting into it. Replace the cap .
Where is a suzuki 1997 sidekick distributor located?"
I think you will have to replace the assembly, Not sure if cam sensor is available seperatly.
To replace the distributor on a 1997 Acura 2.5TL, first disconnect the negative battery cable and remove the engine cover if applicable. Then, disconnect the wiring harness and vacuum lines from the distributor. Remove the bolts securing the distributor, carefully lift it out, and replace it with the new unit, ensuring it aligns properly with the timing marks. Reconnect the wiring and vacuum lines, then reattach the battery cable and start the engine to check for proper operation.
no
Remove wires from old distributor and put on new one [one at a time, noting locations on distributor, or marking wires and locations]. Remove rotor [noting direction it is pointing] and replace with new one pointing in same direction].