0
To replace the heater blower cable on a 1988 Ford F-150, first remove the driver's seat. Then, remove console side panels, glove box, and radio. Pull of AC control knob and detach console from the?æfront frame at its corners. Next, remove console side braces, right vent distribution, steering column cover and left vent distribution. Finally, remove the 10 clips holding the heater blower cable and replace.?æ?æ?æ
What else can I help you with?
How do you replace a heater on a 1988 Honda?
A "heater" or a "heater core"?
How do you replace heater core on 1988 Cadillac El dorado?
To replace the heater core on a 1988 Cadillac Eldorado, first, disconnect the negative battery cable and drain the coolant. Remove the dashboard and the center console to access the heater box. Detach the heater hoses from the engine, then remove the screws securing the heater box to the vehicle. Finally, replace the old heater core with the new one, reassemble the components, and refill the coolant.
Where is the blower motor located on a 1988 Chevy Celebrity eurosport?
If you are asking about the heater blower motor it is mounted to the heater ducting in the engine compartment on the passenger side.
How do you replace a broken throttle cable on a 1988 Ford Ranger?
how do i replace a throttle cable on a 1988 ford ranger pickup
Exactly where is heater blower resister on 1988 Ford Laser?
I found the resister, it is a small module held by 2 small screws on the base of the heater blower behind the glove box.
Where is heater core on 1988 Buick Electra 307?
The heater core is mounted to the passenger side firewall on the 1988 Buick Electra 307. The blower motor needs to be removed to access the heater core.
How do i replace a speedometer cable on a 1988 ford ranger 4wd with a 2.9 engine?
You can replace the speedometer cable, on your 1988 Ford Ranger, by loosening the cable nut on each end of the cable. The cable will come off and can then be replaced.
How do you find a blower motor resistor in a 1988 ford van?
The blower resistor is usually found attached to the A/C-heater box under the hood.
Where is the heater relay on 1988 Chevy Celebrity?
There is a fuse for the blower motor on the fuse panel, I do not know of a relay.
How do you fix your no heat situation on a 1988 Dodge 600 SE Turbo?
Thermostat may be stuck open. Drain the system, replace the thermostat and fill with a 50/50 mix of the correct antifreeze and distilled water. Heater core may be clogged. Replace the heater core. Blend door be stuck. Blower motor may not be running. Repair the problem. Blower motor not working. Either the blower motor is defective, fuse is blown, or the resistor pace is defective.
Where is the heater blower motor resister on a 1988 Dodge Dynasty?
The heater blower motor resistor on a 1988 Dodge Dynasty is typically located under the dashboard on the passenger side of the vehicle. You may need to remove the lower dash panel to access it. The resistor is usually mounted to the heater box and connected to the blower motor with wiring harnesses. Always consult your vehicle’s service manual for specific instructions and safety precautions.
1988 Dakota heater core replacement?
To replace a 1988 Dakota heater core, first discharge the A/C. Then remove the lower instrument panel before removing the heater box unit.
