answersLogoWhite

0

www.odref.com/poulan/pdf/snapper/all/s31sst.pdf

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What type of spark plug for snapper S31SST weed eater?

Champion CJ8Y


Did electrolux produce a snapper weed eater?

Yes, Electrolux did produce a line of outdoor power equipment, including the Snapper brand of weed eaters. Snapper, originally an independent brand, was acquired by Electrolux in the 1980s. The Snapper name has since become synonymous with quality lawn care products, including trimmers and mowers. However, Electrolux later divested its outdoor products division, and Snapper is now owned by Briggs & Stratton.


How easy is it to replace a spark plug wire on gas weed eater?

How easy is it to replace a spark plug wire on a gas weed eater?


How is the carburetor tubing connected to a weed eater?

In general the primer bulb draws fuel from the tank through the carb and then returns it to the tank. Look for "carb" and "tank" on the primer bulb and make the respective connection. A line should come from the tank to the carb. Another from the carb to the primer. and another back to the tank.


How do you replace a Weed eater FL 20 flex shaft?

i need to replace the flex shaft in my weedeater. how do i do it?


How the primer bulb on a weed eater works?

It sucks gas from the gas tank to the carborator using nothing but suction In general the primer bulb draws fuel from the tank through the carb and then returns it to the tank. Look for "carb" and "tank" on the primer bulb and make the respective connection. A line should come from the tank to the carb. Another from the carb to the primer. and another back to the tank.


Craftsman 25cc weed eater model 358795190?

How do you ajust the cab and how do you replace the gas filter.


How do i replace the spring on weedeater?

To replace the spring on a weed eater, first, ensure the tool is unplugged or the battery is removed for safety. Disassemble the weed eater by removing the spool cover and line, then locate the spring, which is usually found in the spool assembly. Remove the old spring and replace it with a new one, ensuring it is properly seated in place. Reassemble the weed eater by putting the spool cover back on and reloading the line before testing the tool.


How can I replace the string on a weed eater?

To replace the string on a weed eater, first, turn off the weed eater and disconnect the spark plug. Then, remove the spool housing and take out the old string. Cut a new piece of string to the appropriate length and thread it through the spool. Wind the string in the direction indicated on the spool and secure the ends. Finally, reassemble the spool housing and reconnect the spark plug before using the weed eater again.


How do I open the weed eater head to replace the trimmer line?

To open the weed eater head to replace the trimmer line, first, locate the tabs on the side of the head. Press and hold these tabs while twisting the head counterclockwise to unlock it. Once unlocked, carefully remove the head to access the spool and replace the trimmer line.


Is the head removable on a weed eater RTE112C?

Yes, the head on a Weed Eater RTE112C is removable. This allows for easy access to replace the cutting line or switch to different attachments if needed. Always refer to the user manual for specific instructions on how to safely remove and replace the head.


Where can you find a manual for a weed eater hand lawn mower?

How to replace springs on a carberater for a 22 in aweedeater lawnmower