0
What else can I help you with?
Why does the speedometer in a 1991 Honda Civic work intermittently?
Problem is most Likely the ground wire on the motor by the thermostat
How do you replace the accessory ac belt on a 1991 Honda Civic 4-door and is there a tensioner and where is it?
The tension belt for a 1991 Honda Civic and located on the driver side of the engine. The pulley is right above the compressor.
Where is a thermostat located on a 1991 Honda Civic?
At the lower end of the top rad hose within the water outlet. Mark
Does a 1991 Honda Civic SI engine fit a 1990 Honda Civic DX?
Yes it will. Make sure you replace your motor mounts as they are most likely torn.
Where is the thermostat located on a 1991 Honda Civic CX?
At the lower end of the top rad hose within the water outlet. Mark
Best transmission fluid 1991 Honda Civic?
best transmission fluid 1991 Honda civic lx
How do you replace the engine coolant on a 1991 Honda Civic?
The engine coolant on a 1991 Honda Civic is replaced by turning the drain petcock and releasing the coolant. The filler cap is then removed and coolant added until the system is full again.
What motor is the best motor for a 1991 civic?
a 1991 Honda civic motor
How to change the rotors on a 1991 Honda Civic?
To change the brake rotors on a 1991 Honda Civic raise the vehicle. Remove the wheels and brake caliper bracket. Remove the brake pads. Loosen the rotor mounting screws and replace the rotors.
Does a 1991 Honda Civic have air bags?
The Civic DX Sedan does 1991 of course
I have a Honda Civic dx and transmission is slipping What other auto transmission Hondas fit a 1991 Honda Civic dx?
1988-1991 Honda civic dx,si,standard civic, crx dx,hf,si any Honda auto trans 1988-1991 will fit it
Where is the thermostat bleeder valve on a 1991 Honda Civic?
On a 1991 Honda Civic, the thermostat bleeder valve is typically located on the thermostat housing. To find it, look for a small valve or screw near the top of the housing, which is where the upper radiator hose connects. This valve is used to release air from the cooling system during coolant refills. Always ensure the engine is cool before attempting to bleed the system to avoid burns.
