To reset an outside security light, first, turn off the power at the circuit breaker or unplug the fixture if it's portable. Wait for about 10-30 seconds before turning the power back on. If the light has a reset button, press it; otherwise, it should automatically reset once power is restored. Finally, check the light settings or motion sensor sensitivity to ensure it’s functioning properly.
To reset the security light on a Pontiac Alero, start by inserting the key into the ignition and turning it to the "On" position without starting the engine. Leave it in this position for about 10 minutes until the security light turns off. Then, turn the key back to the "Off" position, wait a few seconds, and turn it to "On" again. This should reset the security system and turn off the light.
To reset the fashing dash blue security light............disconnect the hot lead on the battery and after about 3 minutes, reconnect it. Light should be off now.
Well that depends on what type of security light bulb it is. Is it for your car, backyard or porch? There are so many out today.
The security light on a 2001 Chevy Astro Van can be reset by disconnecting the battery for 30 seconds. This resets the system and turns out the light until another problem is detected.
To reset the security light on a 2001 Pontiac Firebird, first ensure that you have the correct key that corresponds to your vehicle's security system. Insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in this position for about 10 minutes until the security light turns off, then turn the key to the "Off" position and back to "On" again. This should reset the security system and turn off the light.
To reset the security light on a 1991 Pontiac Firebird, first, ensure that the vehicle is in the "Run" position without starting the engine. Then, turn the ignition off and back to "Run" three times in quick succession. After the third cycle, leave the ignition in "Run" for a few seconds, then turn it off again. This should reset the security system and turn off the security light.
Not 100% sure about a 2003, but on a 1998 you reset the security system by locking and unlocking the doors from the outside with you remote key fob. Hope that helps.
turn the ignition off for 3 minutes
do not start vehicle but turn key to on position then off three times and on that third time leave it on the "on" position takes 10 to 15 minutes to reset the security light should stop blinking.
To reset the security light on a 1997 Oldsmobile, insert the key into the ignition and turn it to the "ON" position without starting the engine. Leave it in this position for about 10 minutes until the security light turns off. Then, turn the key back to the "OFF" position and start the engine. If the security light remains on or the vehicle won't start, you may need to consult a professional for further diagnosis.
You can do it with a scanner. Usually when the security light is flashing it means there is a problem with the passlock system. Dealer item and about $500.00-$700.00 to replace parts & reprogram.
The factory alarm causing the issue would be the security light flashing above the RPM guage. If the security light is flashing and the car will not start, follow the directions listed below. To reset the factory alarm, turn the ignition switch to the "on" position NOT the start position for 15min. You will see the security light go off after 15min.