To reset the anti-theft system on a 2002 Ford Explorer Sport Trac, try the following steps: First, make sure the vehicle is locked and then unlock it using the key or remote. Next, insert the key into the ignition and turn it to the "On" position without starting the engine, then back to "Off." Repeat this process several times (usually 3-5 times) to reset the system. If the problem persists, consult the owner's manual or a professional mechanic for further assistance.
A flashing green light on the AC switch of the 2001 Montero indicates there is a situation that requires attention within the cooling system. The issue could be as minor as a loose connection to an outright system failure.
You may have activated security system if theft light flashing when key is turned, needs reset.
The hourglass flashing on your LT 1050 Cub Cadet typically indicates that the mower's safety features are engaged or that there is a system alert. This could be related to issues such as the seat safety switch being activated, the blades not being engaged, or an error in the electrical system. Refer to the owner's manual for specific guidance on troubleshooting the issue associated with the flashing hourglass.
There are many variations of the useradd command; most standard installations may not have this switch. Please identify which Unix system you are talking about.
It's a self diagnostic feature of the heated seat system. If the switch high and low indicator lamps are both flashing indicates the heated seat element is shorted. If the switch high lamp is flashing and the low is off then the heated seat element is open. This diagnostic feature only lasts for about 1 minute, that's why it goes out.
If your security light is flashing, then you have had what is referred to as a "bad timing cycle" with your Passlok security system. Turn the key to the ON position, and wait until the security light stops flashing - This takes exactly 10 minutes.If the security light WAS flashing, then the 10-minute trick is only a temporary fix - You will need to have your ignition switch replaced.
Flashing the BIOS (basic input/output system) is what you would do if you were to modify your BIOS. Flashing it simply means the act of modifying the way it runs.
If your battery is dead,,,nothing should be flashing. There is no voltage to anything.
The check engine light is flashing due to a problem with the emission system. I flashing check engine light usually indicates a random engine misfire.
If the hazard lights are continuously flashing on your Mercedes C200 R Reg, it could indicate a malfunction in the electrical system or a fault with the hazard switch itself. It may also suggest that the vehicle's alarm system is activated or there's an issue with the battery or alternator. Checking the owner's manual for troubleshooting steps or consulting a mechanic can help diagnose the specific issue.
it is a component of the alarm system
my 97 limited did this in the "auto" mode -- ended up replacing the headlight switch Is the security light also flashing on the dash? There is extensive info on www.jeepforum.com on how to disable and fix the security system. If memory serves, there is a sensor in the door that must be activated when unlocking or the security system will not be turned off and the lights will begin flashing. Is your battery OK? When mine ran down, and I tried to start my Jeep, it triggered the security system as well.