To reset the engine light on a Chevrolet Impala, you can try disconnecting the negative battery terminal for about 15 minutes. This will clear the engine codes and reset the light. Alternatively, you can use an OBD-II scanner to erase the trouble codes directly, which will also turn off the engine light. If the light comes back on after resetting, it’s important to diagnose and address the underlying issue.
Use an OBD scan tool to reset or disconnect the battery
With engine off. Turn key to on. Press accelerator fully three times. This should reset light.
To reset the Check Engine Light you must go to the trunk of your car get a cro-bar and smash the dash board until the light doesn't come on no more...
To reset the Check Engine Light you must go to the trunk of your car get a cro-bar and smash the dash board until the light doesn't come on no more...
To reset the oil change light on a 2013 Chevy Impala, first turn the ignition to the "On" position without starting the engine. Press the gas pedal three times within five seconds. After that, turn the ignition off, then start the engine to ensure the oil change light is reset. If the light remains on, repeat the process.
The check engine light problem will have to be repaired in order to have someone with a scanner to reset it. If the repair is not made then the light will come back on immediately.
Disconnect the red terminal on battery and let it sit for 15-30 minutes, reconnect the battery and check engine light should be off because the computer has been reset.
Assuming you want to clear/reset the check engine light, if you have successfully made repairs to correct what was the cause of the check engine light to go on the light will clear itself after a few drive cycles.
To reset the check engine light on a 2002 Chevy Impala, you can disconnect the negative battery cable for about 15 minutes, which will clear the vehicle's computer memory. Alternatively, you can use an OBD-II scanner to read and clear the trouble codes. After addressing any underlying issues that triggered the light, either method will reset the light. Always ensure that the problem is resolved to prevent the light from coming back on.
To reset the check engine light on a 2003 Chevy Impala, you can disconnect the negative battery terminal for about 10-15 minutes. This will clear the engine control module's memory. Alternatively, you can use an OBD-II scanner to read and clear the trouble codes, which will also turn off the check engine light. Keep in mind that if the underlying issue isn't resolved, the light may come back on.
Fix the problem and hook up a tech 2 to it and clear codes
This light has to be reset by the person doing the oil change. It is not automatic when the oil is changed.