Either unplug the battery for 10 minutes, or go to your local auto store (Orielly or Auto Zone) and borrow their scanner to clear the codes. Ask if you require assistance.
how to change third or center brake light on Chevy beretta 95
How do you reset check engine light for the 2009 Chevy trail blazer?
To reset the computer on a 1990 Chevy Beretta, disconnect the negative battery terminal and leave it disconnected for about 15 minutes. This will clear any stored error codes and reset the engine control unit (ECU). Afterward, reconnect the battery terminal, and the computer will be reset. It’s also a good idea to check for any trouble codes if the check engine light was on before the reset.
You can either bring it in to a Chevy dealer or use a programmer/tuner to reset the check engine light.
If the check engine light is blinking that means an engine cylinder misfire has been detected
To check trouble codes on a 1995 Chevy Beretta, first, locate the diagnostic connector under the dashboard near the steering column. Use a paperclip or jumper wire to connect terminals A and B on the connector. Turn the ignition key to the "On" position without starting the engine, and the check engine light will begin to flash, indicating the trouble codes. Count the flashes to determine the corresponding codes, which can then be referenced to diagnose any issues.
Check
Check your brake fluid. The light will come on due to low fluid. Or someone has yanked your E-Brake.
The check engine light (service engine soon) comes on and stays on when a problem is detected by the self diagnosis system of your vehicle.
It requires an engine scanner to do that.
No, only a problem that effects emissions will set the check engine light.
That REQUIRES an ENGINE SCANNER to do that.