To reset the service light on a 2002 Mitsubishi Lancer, turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within 10 seconds. Turn the ignition off, then turn it back to the "ON" position to confirm that the service light has reset. If the light remains on, repeat the process.
airbag light is on dash
After repairing the failure that caused the code, the lights will reset themselves.
how to reset tire light
The engine light on a Chevy Colorado can be rest by connecting an OBD II reader to the interface port under the dash. Each code can then be reset which will disable the dash light until the error is detected again.
Yes, replace the sensor and have the dash light reset.
The airbag light can not be reset. The light stays on when a malfunction has been detected. You need to have the computer checked for codes and the failure repaired to get the light off.
The airbag light can be reset by resetting the entire control display on most cars. This is the same for a Z3 BMW.
Press and hold the reset button on dash
To reset the dash light indicators on a Toyota Tundra the trucks ECU will need to be reset. The simple way of resetting the ECU requires disconnecting the battery for 5 seconds. When the ECU is reset the lights will be clear.
under the dash above the emergency brake pedal is a light blue colored box, inside that is a reset button that you can insert a small screwdriver to press it and the light will be reset.
If the Check Engine light is on then there is a problem with the emissions system. Once that is repaired the light can be reset. Reset it without repairing the problem and it will just come back on.
I found a reset button under the dash board. You may want to look there first.