To turn off the spanner light on your dashboard, first check your vehicle's manual for specific instructions, as it varies by make and model. Typically, the light indicates a scheduled maintenance reminder, so you may need to perform the required service first, such as an oil change or fluid check. After completing the maintenance, you can often reset the light by pressing the gas pedal three times while the ignition is on or using a specific sequence of buttons on the dashboard. If the light remains on, consider consulting a mechanic for further assistance.
igntion off. press and hold down on the button on the dash. turn ignition on. and wait for the spanner to disappear. turn igntion off. don't be alarmed if the trip meter resets cos it will go back to normal when the spanner light is removed from the dash.
to get the spanner (or service me now) light off all you have to do is turn the ignition on while the engine is off and hold in the trip meter reset button for six seconds or so.
To reset the spanner symbol on the dashboard of a Peugeot 206 1.4 HDi, turn the ignition on without starting the engine. Press and hold the trip reset button on the dashboard, then turn the ignition off while continuing to hold the button. After a few seconds, turn the ignition back on, and the spanner light should reset. Release the button, and the warning light should now be gone.
To turn off the spanner light on a Toyota Hiace, you typically need to reset the maintenance light using the vehicle's odometer. Turn the ignition key to the "ON" position without starting the engine, then press the trip meter button until the odometer displays "000000." Turn the ignition off, then back on, and the spanner light should be reset. If the light persists, it may indicate an actual maintenance issue that needs attention.
To reset the yellow spanner light on the dashboard of a Ford Transit van, first ensure that any underlying issues have been addressed. Then, turn the ignition key to the "On" position without starting the engine. Press the brake pedal and the accelerator pedal fully and hold them for about 10 seconds until the light goes off. Finally, turn off the ignition and restart the van to confirm the reset.
it means the car is ready for a service/ My vectra displays a oil can and spanner when a service is due, if you cannot afford a survive do the following: place keys in ignition but don't turn on, press the button that zeros the miles on the dash and hold it in, place foot on brake and also hold it down, turn ignition on but do not start engine, count to five and release button and pedal, turn ignition off then on again and the service light should havd gone out. When i get a spanner and car come up it says there is an electrical fault.
If you mean the orange light showing oil can and spanner hold both foot brake and throttle, turn on ignition and hold for 30 seconds. The light will flash, turn off ignition job done.
All you have to do is turn the ignition off and press and hold the left button on the dash and then turn your ignition back on there will then be displayed a symbol of a spanner and a timer starting from 10 and wait for it 2 count all the way down then turn your ignition off and job done.
punch it out
To turn off the service spanner light on a Citroën Berlingo, you typically need to reset the service indicator through the vehicle's dashboard. Turn the ignition on without starting the engine, then press the trip reset button until the service spanner icon starts flashing. Finally, keep holding the button until the icon goes off, indicating that the reset is complete. If the light persists, consult the vehicle's manual or a professional for further assistance.
turn ignition to position 2..press brake and throttle together for 15 seconds..light will flash..release and switch off...done!
To reset the spanner light on a Renault Clio, first turn on the ignition without starting the engine. Then, press the accelerator pedal fully three times within five seconds. After this, turn off the ignition and start the engine to verify that the spanner light has been reset. If it remains on, the procedure may need to be repeated or there may be an underlying issue that requires attention.