I recently had to replace my low beam headlight, driver side. There may be a better way but this is what I did. I had to remove the whole headlight assembly. There are, I believe four blots in two areas that hold it in. Remove the bolts and slide the assembly forward, out the front of the car. May take some maneuvering. Once out unscrew the back light holder and remove bad light. Reverse this process to complete the replacement. Notes... be very careful with the new light as they cost in the $80-$120 range. Use clean gloves and be sure the bulb holder is tightened securely. Whole process should take no longer than 30 minutes. There are also two different low beam lights for some Lexus 430's so you may want to take the old light out before purchasing the new light.
Carry it to dealer who will replace on low beam headlight for $15 +/- dollars in about 5 minutes.
Begin by removing the wiring harness from the back of your 1989 Silverado headlight assembly. Remove the low beam headlight assembly retaining bolts. Reverse the process to install your new low beam headlight.
please answer the question
with ur hands
The Low Beam AND High Beam are in the same bulb. The procedure to change it will be in the owners manual.
You can access the low beam headlight bulb from the engine compartment. Push the bulb holder in and turn. The bulb will come out.
replace passenger side low beam headlight
You Have a bad headlight, it's common when a headlight burns out for only the high beam to work, solution change your headlight.
headlight bulbs changed,dimmer swich changed,headlight swich changed.key off headlight work low ,key on goes to brights. unpluged harness check ok at first ,but after a few try hi beam indictor would not go to low m-beam
change the light bulb that does not go on, on low beam, it possible that the wire inside the bulb for low beam is broken
Because it is burnt out. Change the bulb.
is there fuses for high and low headlamp beam on almera