0
What else can I help you with?
The flywheel and the crankshaft are held together in alignment by the A flywheel keyB magnetoC cylinder headD armature coil?
The flywheel and the crankshaft are held together in alignment by the A flywheel key. The flywheel key is a small key that fits into a slot on both the flywheel and the crankshaft, ensuring proper alignment and preventing slippage during operation. This key is crucial for maintaining the timing and functionality of the engine.
The magneto air gap is a precision measurement thats taken between the?
The magneto air gap is a precision measurement that's taken between the edge of the flywheel and the ignition coil armature. The flywheel and the crankshaft are held together in alignment by the flywheel key.
Where is the crankshaft position sinsor 1999 xk8?
The position sensor is at the bottom/back of the engine, where it joins the gearbox. It is held in place by one bolt and connects via a multi plug. It gets its information from markings on the flywheel and this is sent to the ECU to monitor engine timing.
Where is the crankshaft sensor on a 1997 Mazda Protege?
Answerthe camshaft sensor is the distributor but the crankshaft position sensor is located right next to the crankshaft its held on by one bolt
What is the function of main bearing cap?
To keep your crankshaft held in place.
What is crank journal?
on a crankshaft you have a crank journal (more commonly called a main journal) and a rod journal. the main journals of the crankshaft are where and how the crankshaft is held in the block. the rod journals are where your connecting rods are attached to.
What bone held together with?
They are held together by ligaments.
How tightly are the particles held together in gases?
they are not held together.
What made bones held together?
Bones are held together by ligaments.
What are homologous pair held together with?
Homologous pairs of chromosomes are held together by a structure called the synaptonemal complex during meiosis. This complex facilitates the pairing and alignment of homologous chromosomes, allowing for genetic recombination or crossing over. Additionally, cohesion proteins help maintain the connection between sister chromatids within each homologous chromosome.
Where are chromatic held together?
Chromatics are held together at a region called the centromere
How is the fly wheel placed in a standard transmission vehicle and an automatic vehicle?
For both manual and automatic transmission equipped vehicles, the flywheel is actually attached to the rear of the engine crankshaft, not to the transmission itself. But cars that have automatic transmissions originally can have flywheels that are not compatable with manual transmissions. That is because with an auto trans the torque converter is bolted onto the flywheel, and there is no need for a central hole and bearing or bushing in the exact center of the flywheel. On the other hand, with a manual transmissioned car there is a pressure plate bolted to the flywheel, and a clutch plate is sandwiched between the pressure plate and the flywheel. There is also a shaft from the transmission thru the bell housing, through the center of the pressure plate, attached with a toothed surface to the clutch plate, and then the extreme forward point of this shaft goes into a hole in the center of a flywheel, and is held in place by a pilot bushing or pilot bearing that has been pressed into the center hole of the flywheel. So if you take out an automatic transmission and torque converter, you might not be able to bolt in a manual transmission because there might not be a central hole in the original flywheel to hold the pilot bearing/bushing and the tip of the pilot shaft....You may need to also change the flywheel.
