The crankshaft position sensor is located on the front of the transmission case next to the fly wheel on Kia's from 2000 to 2005. On Kia's built after 2005 it is located next to the outlet assembly and the radiator hose inlet.
were is the crankshaft sensor on 2005 mitsubishi lancer
The crankshaft sensor is located behind the air conditioning compressor, which is on the front of the engine. You can replace it using a socket. Tight area. Have replaced one on a 2005 F-350 6.0 powerstroke. Good luck.
Crankshaft sensor
the camshaft position sensor for a 2005 kia optima four cylinder is located on the right side of the valve cover in front of engine its right under the cover on top of engine you should see it when you pull the cover off it has one bolt 10 mm holding it on and one plug. i do believe they said CRANKSHAFT SENSOOOOORRRRRR> not camshaft crankshaft sensor is on passenger side behind the lower timing belt cover right next to the crank pulley. replacing this is not fun. i know, i have done it.
The crankshaft position sensor on a 2005 dodge caravan is mounted on the top side of the bell-housing.
way is my crank sensor over heating on my 2005 colbalt
The crankshaft position sensor is located behind the timing cover and above the crankshaft gear. the timing belt my have to be removed to access the bolts on the sensor.
The answer is yes.
The crankshaft position sensor on a 2005 dodge grand caravan is mounted on the upper side of the bell housing and can be easily accessed from the top.
It's located under the car just behind the starter. Both sensors are there. The Throtle sensor and the Crankshaft sensor. You have to take out the starter to get to it.
NoNo