its 5 quarts for about any engine. 4.5 quarts for the 3 liter v6
The fuse box on a 1993 Chrysler LeBaron is located under the dashboard on the driver's side, near the steering column. You may need to remove a cover or panel to access it. Additionally, there is another fuse box located in the engine compartment, near the battery.
Spend $15 bucks or so for a haynes manual from the local autoparts shop.. your gonna need it.. :)
Need more info - which engine? 2.2/2.5? By 1989 no LeBaron had a carb.
i need to learn how to take out my 1995 Chrysler lebaron convertible motor
you might need to replace the hinge pins.. or the complete hinge
The EGR (Exhaust Gas Recirculation) valve on a 1993 Chrysler LeBaron is typically located on the engine intake manifold, near the throttle body. It's mounted to the engine and connected to the exhaust system through a pipe. To access it, you may need to remove some surrounding components for better visibility and reach. Always refer to a repair manual for specific instructions and diagrams related to your vehicle's configuration.
The engine holds 4.5 quarts.
You will first need to loosen the serpentine belt in order to remove it from the drive pulley. After that, it is bolted to the engine in 2 locations, which should be rather obvious, then remove electrical connections.
You might need to add some hydraulic oil to the pump. The pump is located in the trunk upper right side.. Further info and how2s.. www.autmotiveforums.com/chrysler/ lebaron
Dexron auto trans fluid.
may be on top of the starter and replaced with same. Follow the + battery cable it will connect to the solenoid
should be on the exhaust manifold down pipe... you need to get under the car to see it...