answersLogoWhite

0

Conversion of cable diameter to circle cross-sectional area and vice versa. Scroll down to related links and look at "Conversion of cable diameter to circle cross-sectional area".

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

What is electrical cable size for 18.5kw?

To answer this question the voltage is needed.


what electrical wire size is largest?

Wire size 0000 AWG is the largest electrical wire. It is 0.46 inches in diameter or 11.86 mm in diameter. The cross sectional area is 107.16 mm(squared).


What is the recommended cable size for a 100 amp electrical circuit?

The recommended cable size for a 100 amp electrical circuit is typically 3 AWG copper or 1/0 AWG aluminum.


What is the typical size of hand hole?

The typical size of a hand hole in electrical and telecommunication applications is around 8 inches in diameter. This allows for easy access for maintenance and cable pulling while still being small enough to be securely covered.


Where can find Electrical table for size of cable?

Electricians will use their electrical code book to fine these values.See related links below


When is wire size an electrical hazards?

Wire size becomes an electrical hazard when it is under rated for the amount of current (Amps or I) it has to carry.Current is the flow of electrons in a circuit. If the current is too large for the cable, the cable will be subject to heating, which is a possible fire hazard.


Size 134 kva cable?

A 134 kVA cable typically refers to the size of cable required for a 134 kilovolt-ampere electrical load. The size of the cable needed will depend on factors such as the length of the cable run, the voltage drop allowed, and the type of insulation and conductor material required to safely carry the current. It is recommended to consult with a qualified electrical engineer or contractor to determine the specific cable size needed for your application.


Which conductor size has the largest diameter?

The largest conductor listed in the National Electrical Code is a 2000 kcmil.


What is the recommended grounding rod size for a residential electrical system?

The recommended grounding rod size for a residential electrical system is typically 8 feet in length and 5/8 inch in diameter.


Can you use a 4 awg cable if the old cable is a 6 awg cable?

Yes, you can use a 4 AWG cable to replace a 6 AWG cable, as the 4 AWG cable has a larger diameter and can handle more current. However, it's important to ensure that the new cable is compatible with the existing circuit's rating and that it meets local electrical codes. Additionally, you should verify that the connectors and overcurrent protection devices are appropriate for the larger cable size. Always consult a qualified electrician if you have any doubts.


What is the ring size for 20mm?

A ring size of 20mm typically corresponds to a size 10 in the U.S. ring sizing system. To convert millimeters to U.S. sizes, the diameter (in mm) is measured, and each size increment usually represents a change of about 0.4mm in diameter. Therefore, a 20mm diameter ring would fit a U.S. size 10 comfortably.


What is the diameter size of EMT conduit?

EMT is electrical metallic tubing. In the electrical trade there are nominal sizes expressed as a standard size. To answer your question you must state the conduit size in either electrical terms or in standard size terms to get a conversion size.For example standard size 1/2" EMT has an actual diameter size of 3/4" and the 1/2"EMT connector for the 1/2" EMT conduit needs a 7/8" hole.Likewise with 3/4" EMT the actual outside diameter is 15/16" and the 3/4" EMT connector needs a 1-1/8" hole.