answersLogoWhite

0

To replace the water pump on a 1996 Ford Windstar, first ensure the engine is cool, then disconnect the battery and drain the coolant. Remove the serpentine belt, and take off any components blocking access to the water pump, such as the alternator or brackets. Unbolt the water pump from the engine, clean the mounting surface, and install the new pump with a new gasket. Reassemble all removed components, refill the coolant, and reconnect the battery.

User Avatar

AnswerBot

4w ago

What else can I help you with?

Related Questions

Replace freeze plug on a 1998 ford Windstar?

Replace freeze plug in a 1998 ford windstar ?


How do you replace the GEM module on a 1996 Ford Windstar?

The GEM in a ford windstar is located up inside the dash, above and to the left of the gas pedal. it's held in with a single bolt.


How much should it cost to replace the water pump on a '95 Ford Windstar 3.8 V6?

I just had my water pump replaced on my '96 Windstar at a Ford dealer and it cost me $575.


What type of oil for 1996 ford windstar?

( 5W-30 ) is the preferred engine oil , according to the 1996 Ford Windstar Owner Guide


Where is the inside fuse box on a 1996 ford windstar?

On a 1996 Ford Windstar : Under the dash on the drivers side , not too far from the inside hood release


Where is the tachometer wire on a 1996 Ford Windstar GL?

i dont know whwere is the tachometer wire of 2001 ford windstar


Replace rear side window 99 ford windstar?

where can i buy a side window for my 99 ford windstar lx


How do you replace the evaporator in a 99 Ford Windstar 3.8L?

I don't know how to do it, but the dealer is charging me $2075.00 to replace it on my 2000 Windstar!


How heavy is the 1996 ford windstar sport van?

3800lbs


Were is cylyder 1an 4 on a 1996 ford Windstar?

On a 1996 Ford Windstar , V6 engine : firewall 1-----2-----3 4-----5-----6 front of vehicle > driver


Need emission diagram for 1996 Ford WindStar 3.8L engine?

Emission diagram for 1996 ford thunderbird 3.8l


Where is the pressure switch on a 1996 ford windstar air conditioning system?

The pressure switch for the air conditioning system on a 1996 Ford Windstar is located in the accumulator. It triggers when the compressor will turn on and off.