Resetting the maintenance service indicator on G.L.K 2010
reset service light on 2010 ml 550
How do you reset maint read light on 2010 corolla
Turn the ignition switch to the ON (II) position.Press the select/reset knob repeatedly until the engine oil life indicator is displayed.Press the select/reset knob for about 10 seconds. The engine oil life and the maintenance item code(s) will blink.Press the select/reset knob for another 5 seconds. The maintenance item code(s) will disappear, and the engine oil life will reset to "100."NOTE: After the engine oil life and maintenance item codes start to flash (blink) you must RELEASE the reset knob and press again for another 5 seconds. It will then reset.
How to reset oil maintanance on a lexus gx 460
To reset the low brake pad indicator on 2010 Ford Trans IT simply turn on the ignition and press the foot brake and the accelerator simultaneously. The accelerator and the foot brake should be pressed at the same time.
You will find that info in the owners manual.
Service wrench on 2010 c 250
Just press the trip reset button
I Think its a main dealer job only as they use a guided function with the Audi VAS computer to reset the service display
From page 232 of the owner's manual: (go to dodge.com to download)To reset the oil change indicator system (afterperforming the scheduled maintenance), refer to thefollowing procedure:1. Turn the ignition switch to the ON position (Do notstart the engine).2. Fully depress the accelerator pedal slowly three timeswithin 10 seconds.3. Turn the ignition switch to the OFF/LOCK position.NOTE: If the indicator message illuminates when youstart the vehicle, the oil change indicator system did notreset. If necessary repeat this procedure.
pressing the red button, everyone says not to but in this case u should.
Key on, engine off. Press the gas pedal to the floor three times in ten seconds.