reset service light on 2010 ml 550
Resetting the maintenance service indicator on G.L.K 2010
To reset the low brake pad indicator on 2010 Ford Trans IT simply turn on the ignition and press the foot brake and the accelerator simultaneously. The accelerator and the foot brake should be pressed at the same time.
To reset the service indicator on a 2010 Mercedes ML 350 CDI BlueTEC, turn the ignition key to the "On" position without starting the engine. Press the gas pedal three times within 10 seconds. Then, turn the ignition off and back on to complete the reset. Make sure to check the owner's manual for any specific instructions or variations for your model.
Service wrench on 2010 c 250
Just press the trip reset button
I Think its a main dealer job only as they use a guided function with the Audi VAS computer to reset the service display
To reset the low tire pressure indicator light on a 2010 Jeep Patriot, first ensure that all tires are properly inflated to the recommended pressure. Then, turn the ignition to the "On" position without starting the engine. Press the gas pedal three times within ten seconds, then turn the ignition off. Start the engine, and the light should be reset.
A B1 service for a 2010 Mercedes E200 CDI BlueEfficiency typically includes an oil change, replacement of the oil filter, and a thorough inspection of key components such as brakes, tires, and fluid levels. Additionally, the service may involve checking and, if necessary, replacing the air filter and cabin filter. The technician will also update the vehicle's service history and reset the service indicator. Regular service helps ensure optimal performance and longevity of the vehicle.
Key on, engine off. Press the gas pedal to the floor three times in ten seconds.
Resetting the Service Reminder DisplayCaution!Do not reset the service reminder between service intervals; otherwise, incorrect information will be displayed.Switch off the ignition.Push and hold down the reset "0.0/set" button.Switch on the ignition.Release the "0.0/set" button and push the clock setting button within 20 seconds.
The only way to clear the service light is by using a scan tool on the newer models.
Turn the key on but do not start the truck then slowly press the gas pedal to the floor 3 times