0
I have a 95 Altima. I tested the EGR solenoid valve by using a multimeter. Disconnect the two-wire connector that plugs into the solenoid valve. When engine is cold and ignition turned on the two wires from the harness should read 12volts. Momentarily touch the connector to the socket on the solenoid valve and you should hear an audible click as the solenoid valve snaps open and closed. Also you can check the continuity of the solenoid valve coil. It should show good continuity and not "open." If you can read ohms on your meter you can also check the coil and it should read about 50 ohms if it is good. I was getting a P1400 code and thought my solenoid valve might be bad. It tested good so I removed the EGR valve and found it to be carboned up. A little choke cleaner fixed it up. Also the metal return tube that goes to the exhaust manifold was also carboned up. So far this has cured my problem.
What else can I help you with?
What is meaning of computer code po403?
It means something is not right with the car's EGR valve.These are possible causes, starting with the most common.Bad EGR solenoidExcessive resistance in control circuit (PCM controlled ground) due to an open, chafing or damage to the harnessPoor connection at the EGR solenoid harness (worn or loose pins)Water intrusion at the EGR solenoid harnessBlockage in EGR control solenoid holding solenoid open or closed causing excessive resistanceLoss of supply voltage to EGR solenoid
What is an EGR vacuum solenoid on a 1991 4.3 s10 and what it does?
The EGR (Exhaust Gas Recirculation) valve opens when vacuum is applied. The EGR vacuum solenoid opens and closes the vacuum supply to the EGR valve when it is commanded to do so by the ECM (Engine Control Module).
What is the sensor PO400 on a 1998 esteem?
EGR { Exhaust Gas Recirculation} Flow Malfunction Early Exhaust Gas Recirculation (EGR) systems components include and EGR Valve, and Engine Control Μodule (ECΜ) Controlled Vacuum Switch Valve or EGR Solenoid and an EGR Vacuum Μodulator. Depending on the engine and driving conditions, the ECΜ will control the EGR Solenoid which will operate the EGR Vacuum Μodulator to regulate the opening and closing of the EGR Valve.
Is there a way to test the egr valve on my 1992 subaru loyale Check engine light is on and telling me egr is bad.?
this is likely the solenoid that controls the egr. follow the tiny hose attached to the egr back to a small electrical solenoid. that part is best bought at a junkyard if possible because it is expensive new.
Where is the solenoid on a 1988 Chrysler Lebaron?
Starter solenoid: on the starter.EGR: on the egr valvetransmission: on the valve body in the trans.Starter solenoid: on the starter.EGR: on the egr valvetransmission: on the valve body in the trans.
Does a 99 Mitsubishi diamante have an egr solenoid or just the egr valve. If it does have the solenoid where is it related to the valve?
Yes, the Diamante has an EGR solenoid. On any Mitsubishi, if the car has an egr valve, it has a solenoid to operate the valve. Just follow the vacuum line from the valve and it will go to the solenoid. There may be another one way valve between the valve and the solenoid, though. The solenoid is electronic.
What does the egr flow malfunction mean on a 1996 Ford Aspire?
Plugged EGR passage which restricts the flow of exhaust gasses, faulty EGR solenoid, faulty EGR solenoid wiring/harness, vacuum lines damaged or disconnected to the EGR valve solenoid or to the EGR valve, or a faulty EGR valve.
What does EGR control solenoid valve do?
The EGR (Exhaust Gas Recirculation) control solenoid valve regulates the flow of exhaust gases back into the engine's intake manifold. This process reduces nitrogen oxide (NOx) emissions by lowering combustion temperatures and improving fuel efficiency. The valve opens and closes based on engine conditions, allowing precise control of the EGR system to optimize performance and emissions. Proper functioning of the EGR solenoid is crucial for meeting environmental regulations and maintaining engine efficiency.
What does P0400 OBD trouble code mean and how do you repair it?
P0400 - Exhaust Gas Recirculation Flow Malfunction Possible causes - Exhaust Gas Recirculation (EGR) solenoid valve harness is open or shorted - Exhaust Gas Recirculation (EGR) solenoid valve circuit poor electrical connection - Exhaust Gas Recirculation (EGR) volume control valve stuck closed - Faulty Exhaust Gas Recirculation (EGR) volume control solenoid valve - Dead (Weak) battery - Faulty EGR temperature sensor and circuit - Faulty EGR Valve
Where is egr control solenoid filter located on 95 Dakota?
It's inside the transducer. The black solenoid that's attached to the egr valve by two vac lines. 3.9L and 5.2L have a power plug and 2.5L isn't powered.
Where do you find the egr on a 96 mercury villager?
The EGR valve is located on the top of the intake manifold rearward of the throttle crank under the cowl. If you suspect a problem with the system, you may want to check the EGR control solenoid, the EGR control backpressure transducer and all vacuum hoses.
Where is the egr valve solenoid located on a 2005 dodge stratus?
On the egr valve.
