0
Its got an air release valve one the slave cylinder. Get somebody to pump the brakes for you a couple of times then torque the release valve to release the air then tighten back up. Just repeat this process about 5 - 7 times (thats all it took for mine) when you are getting close to getting finished the pedal should be firm when you push it.
What else can I help you with?
How do you bleed a clutch on a Nissan stanza?
To bleed a clutch on a Nissan Stanza, you need to find the bleed-off valve, usually somewhere near the slave cylinder.
How do you put a new clutch slave cylinder on your 2006 Nissan Frontier?
To install a new clutch slave cylinder on a 2006 Nissan Frontier, first, ensure the vehicle is on a level surface and the engine is off. Remove the old slave cylinder by disconnecting the hydraulic line and unbolting it from the transmission. Install the new slave cylinder in the reverse order, making sure to properly secure it and reconnect the hydraulic line. Finally, bleed the clutch system to remove any air and ensure proper function.
How do you bleed the clutch line on a Nissan 240SX?
The same way you bleed brakes, but use the little bleeder valve on the slave cylinder. The same way you bleed brakes, but use the little bleeder valve on the slave cylinder.
How do you replace a cluth slave cylinder on a 1985 Nissan 720 4x4 ST model?
remove 2 bolts holding it on,then replace, follow line back to bleeder valve,bleed,then bleed at slave cylinder
Bleed clutch cylinder on a 1991 Nissan 240sx still no presure on the padel?
You must bleed the clutch dampener before bleeding the slave cylinder its that weird curvey steel hose before the slave unter the passangers feet. look arount the side of the dampner for the bleed screw
How would you bleed a clutch cylinder for a 1998 Nissan Frontier?
To bleed the clutch cylinder on a 1998 Nissan Frontier, start by locating the bleeder valve on the slave cylinder. Attach a clear plastic hose to the valve and place the other end in a container to catch fluid. Have an assistant pump the clutch pedal several times, then hold it down while you open the bleeder valve to release air and fluid; close the valve before your assistant releases the pedal. Repeat this process until no air bubbles are visible in the fluid.
How do you replace a clutch slave cylinder on a 92 Nissan truck?
first take off slave cylinder, it should be mounted on your frame, then take off hoses, connect hoses to new slave cylinder. mount slave cylinder back to frame and bleed ur clutch for f*****g hours.
How do you tell if the clutch master cylinder is gone out on a 87 king-cab Nissan truck?
first check your clutch slave cylinder for leaks, if its leaking ,replace and bleed system,if its not leaking,bleed system ,dont forget to bleed clutch damperand if its still not right, then replace clutch master cylinder.
I replaced a 1991 Nissan 204sx slave cylinder. Now it will not build up pressure and the pedal stays to the floor. What is the problem?
You need to bleed the clutch
How do you bleed a slave cylinder on an Isuzu hombre?
You do something.
How do you adjust the clutch pedal on a 2000 Nissan Frontier with 90000 miles?
theres no adjustment. need to replace the clutch.or if clutch is new you need to bleed the slave cilinder by the transmission
How do you bleed the slave cylinder on a 1993 Jeep Wrangler?
Right above the slave cylinder there is a bleeder screw. Just unsrew it and have someone hold in the clutch to start the bleed.
