If the sensor is the problem then the answer is yes. But unless you know how to diagnose the problem you are just throwing parts at the problem and may spend lots of money and still not have it repaire. I suggest you have this repaired by a professional who knows what they are doing.
Not sure what out put sensor you speak of but, in most cases after you replace the correct faulty part, the ecm will shut off the check engine light and eventually clear the code(s) after so many ignition cycles.
Try cleaning or replacing the Idle air control sensor.
If the ejector pumps keeps running, it may have a faulty shut-off sensor. The best thing to do is to try replacing the sensor and see if that corrects the problem.
check your oil pressure sensor, it is an easy fix.
An oil level sensor will shut down the Ford Expedition. If the oil level sensor senses that the vehicle is low on oil, a light will alert you to the fact before the vehicle shuts down.
Perhaps the collision sensor that shuts the fuel off on impact is set too sensitive
If your motion sensor light won't shut off, first check if there's any obstruction blocking the sensor that may be causing it to stay activated. Adjust the sensitivity settings on the sensor, as they might be set too high. If the problem persists, try turning the light off at the circuit breaker for a few minutes to reset it. If none of these solutions work, consider consulting the manufacturer's manual or contacting a professional electrician.
If the cam sensor was the cause, the light will eventually shut off. It may take a couple of weeks.
Fill washer resevoir - if it does not shut off possiby a bad sensor
check your interior light...my manual says it can cause the problem
If the ABS light is on , a malfunction has been detected . It could be a fuse , a sensor , or some other problem
Tampering or replacing ignition that does not match up with your key will cause your security to shut your car down.