That is the dash.
you cannot service panel lights on 2000 impala . you hav to replace the instrument cluster.
The instrument panel is the gauges and warning lights that are in front of the driver and behind the steering wheel
You will need to take the old instrument panel cluster assembly to a GM dealership so they can order the proper replacement cluster and it must have the mileage programmed at the dealer when installed in the vehicle as well as programmed. Without programming the IPC will not function properly. Clusters are sent in for exchange only.
To replace the instrument panel lights in a 2000 Volvo S70, first, disconnect the car battery to ensure safety. Remove the trim surrounding the instrument panel by carefully prying it off. Unscrew the panel screws, then pull the instrument cluster out. Finally, twist the bulb sockets counterclockwise to remove the old bulbs and replace them with new ones before reassembling the panel.
I just need to figure out how to take my door panels off my car, 2000 Mitsubishi Eclipse, so I can install some new speakers.
In a 2000 Toyota Solara, the instrument panel lights are typically controlled by the "Illumination" fuse. This fuse is usually located in the engine compartment fuse box or the interior fuse panel. If the instrument panel lights are not functioning, checking and replacing the Illumination fuse may resolve the issue. Always consult the owner's manual for the exact location and specifications.
To remove the instrument panel from a 2000 Volkswagen Polo, first, disconnect the battery to ensure safety. Remove the screws or bolts securing the panel, typically located around the edges and behind any trim pieces. Carefully pry off any trim or bezel surrounding the panel, then gently pull the instrument panel out, disconnecting any electrical connectors. Be cautious not to damage any clips or wires during the process.
2000 Mitsubishi eclipse 2000 Mitsubishi eclipse 2000 Mitsubishi eclipse
To remove the instrument panel in a 2000 Oldsmobile Intrigue, start by disconnecting the negative battery cable to ensure safety. Next, remove any trim pieces surrounding the panel, typically using a flathead screwdriver or a trim removal tool. Unscrew the bolts securing the instrument panel, then gently pull it out, taking care to disconnect any electrical connectors behind it. Make sure to document where each screw and connector goes for reassembly.
The fuse is identified as "SRS" (Supplemental Restraint System) and is located in the Driver's Side Instrument Panel Fuse Box. To access it, open driver's door & remove the Cover on the side of the Instrument Panel...
2000-2004 Eclipse models have adopted a fuel pump module which includes a fuel filter. Fuel filter replacement is not listed in the maintenance table.