buy a aftermarket wiring harness if your factory harness is cut good luck use a test light or meter to find your constant power and ignition then trace speaker wires the positives on the rear speakers is dark collered wires little hint to limit your problems
I'm not certain that the vehicle came factory-equipped with a trailer wiring harness. HOWEVER - if it does exist look CAREFULLY underneath the rear of the CR-V for the wiring to be tucked up and into the rear area somewhere, perhaps underneath the rear bumper housing.
Check wiring harness under vehicle and under left rear tailights
The trailer wiring kit is available from Jeep at about $125 and plugs into a wiring connector accessible through a panel in the left rear (inside) fender panel (behind the spare tire, near the left rear turn signal) with the trailer wiring harness routed through a grommet in the bottom of the compartment
To replace the rear speakers in a 1979 Trans Am, start by removing the rear seat and the rear speaker grille to access the speakers. Disconnect the old speakers by unscrewing them and unplugging the wiring harness. Install the new speakers by connecting them to the wiring harness and securing them in place with screws. Finally, reattach the speaker grille and the rear seat to complete the installation.
I'm not certain that the vehicle came factory-equipped with a trailer wiring harness. HOWEVER - if it does exist look CAREFULLY underneath the rear of the CR-V for the wiring to be tucked up and into the rear area somewhere, perhaps underneath the rear bumper housing.
it's at the rear behind the left side cover. once the cover is pull you should see a plug in. You may have to go to the dealer to get the proper wiring harness.
It should be by or under the rear of the vehicle.
The wiring diagram for the Pioneer DEH-23UB typically includes connections for power, ground, speaker outputs, and antenna. The main power wire is usually connected to a constant 12V source, while the ignition lead connects to a switched 12V source. Speaker wires are color-coded for easy identification, with specific colors corresponding to left, right, front, and rear speakers. For the exact wiring configuration, it's best to refer to the official installation manual or a wiring harness specific to your vehicle.
On my OBW, it's in the left rear stowage compartment with the jack...
Attach the wiring harness to the back of your 2002 Chevy new rear speakers. Secure the rear speakers with the retaining screws. Put the rear speaker covers on.
Begin by removing the cover from your rear speakers. Remove the rear speaker retaining screws. Remove the wiring harness from the back of the speaker. The rear speakers will come out.