Depends on the vehicle. Some are the same if you have rack and pinion steering. If you have a standard steering box with a center link, left and right are different.
A muscle car is factory built, and a hot rod, home built.
The crank shaft runs right down the middle of the lower engine. The connecting rods & pistons are attached to it.
Rods and cones are two types of photoreceptor cells in the human eye. Rods are more sensitive to low light and help with night vision, while cones are responsible for color vision and work best in bright light.
Put the 7cm and 5 cm rods together = 12 cm Put the 9cm and 2cm rods together = 11 cm Difference between is 1cm thus, you can use that difference to measure 1 cm.
cone cells help you see colors while rod cells helps you see in dim light
Rods and cones are two types of photoreceptor cells in the human eye. Rods are more sensitive to low light and help with night vision, while cones are responsible for color vision and work best in bright light.
I can only answer this for a 2000 Suburban. Lift out the middle tray on the Left side of the truck right next to the third seat. Right next to the left rear side glass. The tools are hidden in the compartment right below the left rear side glass. Hope this helps.
None
its just behind the engine and can easily seen from left side between two rods supporting the starter
You can insert two screws or nails in the back of the rod for each bracket to prevent the latter from moving left or right. the space between the screws should be the same as the width of the bracket.
The steering would be sloppy, difficult to keep vehicle going straight, probably wander left and right, uneven tire wear,
The difference in the ac/ dc , or polarity of welding rods is in the makeup of the flux coating , or the alloy of the metal, and in the case of SMAW ( Shielded metal arc welding ) rods , which have a flux coating, are usually marked on the base of the rod.