0
Yes it can leak water through the intake gasket into the runners in the head and smoke white, But the water ports and intake runners are a long way from each other because of the design. SO I would say that you have a cracked head are bad head gasket that is making it smoke. Did you get the engine hot are over heat it ? If so then you have a head gasket or head problem not an intake problem.
What else can I help you with?
How do you repair a cracked manifold on my suburban?
It must be REPLACED with another 1.
1995 Cadillac It smells like gas but there isn't any visible gas coming out of it any ideas?
check if there is any fuel leaking from the exhaust. If so you might be having problems with your intake manifold. Tha usually happens when the starter has been replaced, it might have been replaced incorrectly.
Does a 95 Chevy Suburban have a carburetor?
No, a 1995 Chevrolet Suburban does not have a carburetor. The carburetors were changed in 1995 and replaced with fuel injectors.
How do you remove the ignition switch of a 97 Suburban?
you can take it to be replaced it has a recall on them
What causes oil loss in a 2003 suburban?
There are a few different reasons for oil loss in a 2003 Suburban. This could be because the oil filter needs to be replaced or the oil drain plug needs to be replaced.
When Lincoln Town Cars intake manifold has been replaced now it wont even crank over battery getting 12 volts any ideas was running fine before?
The reason a Lincoln Town Car might not start after the intake manifold was replaced could be that the MAP (Manifold Absolute Pressure) sensor was not installed properly after the manifold was replaced. The computer might also need to be reset.
Why might a 1994 Chevrolet Suburban not be getting hot?
If a 1994 Chevrolet Suburban is not getting hot, it may need to heating core replaced.
Host A in the Clerical office failed and was replaced?
Number 4 . Subnet mask incorrectly entered
How do you install an exhaust manifold on a Renault?
The exhaust manifold needs to have a gasket in place to help seal the juncture between the manifold and the engine. After the gasket and gasket sealer are in place, tighten the bolts for the exhaust manifold. The exhaust pipe can then be replaced on the new exhaust manifold.
You have replaced your exhaust system with a new one up to the exhaust manifold the exhaust manifold looks fine but you still get loud engine noise inside the car?
have you checked to see if there is any broken bolt on the manifold, or worped manifold, burnt manifold gasket
Leak in eshaust manifold 92 Camaro?
bad gasket. needs replaced
What is the problem on a 1994 suburban if the transmission will not change from first gear?
TIME TO GET THE TRANSMISSION REPLACED
