0
The location of the crankshaft position sensor depends on which engine your car has.
If it is the 2.5L 4 cylinder it is below the intake manifold behind the ignition module.
If it is the 2.8L V6 it is below the exhaust manifold on the firewall side of the engine block, in about the center of the engine.
What else can I help you with?
Where is the location of the Crank Sensor on a 3.1 Corsica Engine?
The Chevrolet Corsica 3.1 liter engine crank sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crank sensor.
How do you remove crank sensor from Chevrolet astro 93?
That year did not USE a Crank sensor.
Where is the crank position sensor on a 1999 Chevrolet Malibu?
The 1999 Chevrolet Alamo crank shaft position sensor is located on the back of the engine. You will need to remove the rear engine cover in order to access the crank position sensor.
Diagram for a crank sensor for a 1989 Chevrolet Celebrity?
You should be able to find a wiring diagram in either a factory service manual or a Chilton or Haynes manual. The wire goes from the ignition module to the crankshaft sensor.
91 Dakota crank sensor location 3.9 v6?
No Crank Sensor until 1992
What is the Location of crank shaft sensor 1992 Chevy truck?
That year model does not have a crank sensor.
Crank sensor location 84 Chevy 2.0?
They did not use a crank sensor in 1984, There was no need for 1
What is the location of the crank position sensor on a 1990 Firebird 3.1?
it does not have a crank position sensor. it uses the ignition control module as a crank sensor. it is in the distributor cap
Geo Metro crank sensor location?
LOL, some dont have crank sensors my friend! if you dont have a crank sensor by your oil pan then you have a bad distributor sensor!
Where is the crank and camshaft sensor located on a 98 Chevrolet silverado?
The cam sensor is the distributor, The crank sensor is in the front bottom left side of the timing cover. Behind the balancer.
Is there a picture of crank sensor location for a 1987 2.8 Chevy Celebrity?
I found a sketch of the crank shaft position sensor location in my factory service manual, but have no way to post it here. I can tell you that it is on the side of the engine block next to the firewall and below the exhaust manifold. It is close to the center of the block. The sensor is held in by one bolt. It is a bear to get to but it can be replaced with the engine in the car.
Diagram of a crank position sensor in a 2002 Nissan Frontier?
location of a crank shaft sensor on a nissan frontier 2002
