Service indicator reset switch ignition to position 2 press brake & accelerator pedals together for 15 seconds service indicator will flash when reset release pedals turn ignition off hope this was useful Mike 2
its your service light
needs a service
you are low in oil and you need a service
To turn off the spanner light on a 2002 Ford Transit, first, ensure that any underlying issues indicated by the light are addressed, such as scheduled maintenance or repairs. After resolving any issues, you can reset the light by turning the ignition key to the "on" position without starting the engine, then pressing the accelerator pedal three times within 10 seconds. Finally, turn the ignition off and then back on to check if the light has reset. If it persists, consult a professional mechanic for further diagnosis.
Oil Can = Fill up oil, low oilSpanner = Service needed
The rear light fuse on a 2002 Ford Transit is located in the main fuse panel. This panel is next to the hood release.
Ford Transit Connect was created in 2002.
To reset the yellow spanner light on the dashboard of a Ford Transit van, first ensure that any underlying issues have been addressed. Then, turn the ignition key to the "On" position without starting the engine. Press the brake pedal and the accelerator pedal fully and hold them for about 10 seconds until the light goes off. Finally, turn off the ignition and restart the van to confirm the reset.
The spanner light on a 2005 Ford Transit indicates a potential issue with the vehicle's transmission or drivetrain. It typically signals that the vehicle's onboard diagnostics system has detected a fault, and it may require attention or inspection. If the light is illuminated, it's advisable to check for any diagnostic trouble codes (DTCs) and consult a mechanic to ensure proper functioning and avoid further damage.
hi it means you need to get your van serviced
It is to advise the driver that the van requires a service.
The glow plug and red spanner light on a 2004 Ford Transit typically indicate a potential issue with the engine or the glow plug system. The glow plug light signals that the vehicle is in the pre-heating phase, which is crucial for starting in cold conditions, while the red spanner light indicates a fault that needs attention, such as a problem with the engine management system. It's advisable to have the vehicle's diagnostic codes read to identify the specific issue and address it promptly.