answersLogoWhite

0

you could've broke the clutch cable

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

What is the poor habit of resting your foot on the clutch pedal while driving a stick-shift vehicle?

Answer: "Riding the clutch"


What cause engine to accelerate while driving?

Gasoline pedal/air intake pedal


What Actions Use Up Manual Transmission Clutches?

assuming clutch linkage is properly adjusted, holding foot on clutch pedal while driving, letting the clutch pedal out too slowly starting out in a higher gear than 1st


Clutch adjustment on 91 Mazda Navajo?

It may be as simple as an auto adjustment. If you have installed a new clutch/ clutch cable. If it is auto adj all you have to do is lift UP on the clutch pedal with your foot while driving.


What causes premature clutch wear at 35000 km on a Brazilian 2005 VW Gol even if you drive very carefully?

Improper use of the clutch or improper adjustment will wear the driven plate out very quickly. The clutch pedal free play should be at least 1/2" or 12 mm. Don't rest your foot on the pedal while driving. Both will cause wear.


Acura Integra1998 Manual shift clutch pedal too hard to press needs two feet help?

The throw out ( release) bearing is binding on the shaft and will need to be replaced. You might as well put in a new clutch while you are at it. If you have a habit of driving and resting your left foot on the clutch pedal you might want to train yourself to stop, that is a common cause of premature release bearing failure


What would cause a 2000 Toyota Tacoma to surge at idle and while driving?

maybe the clutch


How to Adjust clutch pedal height peugeot 307?

To adjust the clutch pedal height in the Peugeot 307 locate the adjuster bolt on the floor under the clutch pedal. Loosen the bolt and pull out the pedal to the proper height then tighten the bolt. To make the clutch pedal lower for the operator simply push in on the clutch pedal while the adjuster bolt is loose, then tighten the bolt.


Why is the clutch pedal soft on a 1989 Nissan Sentra?

Because you need a new one, sorry pal, just had to do the same with my jeep. try not to ride the clutch while driving, it'll only make it worse


Why would the clutch pedal of a 1991 Nissan 300zx NA sink to the floor and stay while driving?

The clutch pedal of a 1991 Nissan 300ZX NA sinking to the floor and staying there while driving is likely due to a hydraulic issue, such as a leak in the clutch master or slave cylinder, or low fluid levels in the clutch system. Air in the hydraulic lines can also prevent proper engagement. Additionally, a failing clutch release bearing or a damaged clutch fork might contribute to this problem. It's important to address these issues promptly to avoid further damage to the transmission.


For a manual transmission will the clutch wear faster if you go down a hill on neutral?

No, it will not wear the clutch faster That is a VERY unsafe driving practice. By putting the car's transmission into neutral, while going down a hill, you are now relying 100 percent on the car's brakes to slow and stop the car. This is very dangerous. The much safer way to do this is..........downshift to second gear and use the engine and the gears to slow down, while "covering the brake pedal" with your left foot, in case you need to stop rapidly. With a manual transmission, when you put it in neutral, you have dis-connected the engine from the drive wheels. The clutch pedal and the clutch plate are the parts that allow you to change gears without grinding them. Excessive clutch plate wear comes from "riding the clutch pedal" with your left foot, while driving along. Doing that partially engages the clutch plate, and makes it wear out rapidly. You should take your left foot completely OFF the clutch pedal when NOT shifting gears, and place it on the floor, away from the pedal.


What would cause a 2006 KIA Sedona to stall while driving after it has been setting for a while and do it multiple times?

Torque Converter Clutch Solenoid is a possibility.