They often stick, with emergency brake OFF, vehicle jacked and blocked, hold a small block of 2x4 against inside rim of drum, hit it with a heavy hammer, rotate drum and keep hitting on opposite sides.
They often stick, with emergency brake OFF, vehicle jacked and blocked, hold a small block of 2x4 against inside rim of drum, hit it with a heavy hammer, rotate drum and keep hitting on opposite sides.
how do you remove rear brake drum on a suzuki 2004 xl7
To remove a rear brake drum on a Chrysler, first ensure the vehicle is safely elevated and secured on jack stands. Remove the wheel, then locate and remove any retaining screws or clips securing the drum. If the drum is stuck, gently tap it with a hammer or use a brake drum puller to loosen it. Once free, slide the drum off the hub to access the brake components.
There drum, the front are disc and rear are drum
Yes
Drum - 2004 is rated/received certificates of: Australia:MA
Remove wheel Make sure parking brake is released fully Remove and discard spring clips on lug bolts if any Hit one side with a hammer while exerting pulling pressure on the opposite side - drum should slide off
They often stick, with emergency brake OFF, vehicle jacked and blocked, use s small block off 2x4 against inside rim of drum, hit it with a heay hammer, rotate drum and keep hitting on opposite sides.
Remove the calipers on the front ones and they should slide right out. On the back after you remove the caliper , you need a screw that fits the 2 holes by the lug nuts and screw it in until the rotor pops then just slide it out. keep your parking brake off. The rear one is also the parking brake drum. If your rotor is rusted to the wheel bearing, which it probably will be, use a hammer on it to attempt to break loose the rust and release the rotor.
Drum's Not Dead was created in 2004.
drum brakes
It could have either.