answersLogoWhite
Chrysler Sebring
Ford Expedition XLT
Ford Explorer XLT

How do you remove and replace the front and back rotors on a 1996 Chrysler Sebring Coupe?


Top Answer
User Avatar
Wiki User
2015-07-15 21:00:23
2015-07-15 21:00:23

Remove the calipers on the front ones and they should slide right out. On the back after you remove the caliper , you need a screw that fits the 2 holes by the lug nuts and screw it in until the rotor pops then just slide it out. keep your parking brake off. The rear one is also the parking brake drum.

If your rotor is rusted to the wheel bearing, which it probably will be, use a hammer on it to attempt to break loose the rust and release the rotor.

Related Questions

User Avatar

when you remove the caliper on the disk brake by removing the bolts on the inside of the caliper the rotor just slides off, the only thing holding the rotor in place is the wheel.

User Avatar

Remove wheels then push back the pistons then remove calipers and brackets then the rotors.

User Avatar

Should be the "peel off" type Remove wheel Remove caliper mounting bolts Slide caliper off rotor Rotor should slide off hub assembly

User Avatar

pull off the front wheels. remove the calipers. remove the two screws that hold on the rotors. replace the rotors and reverse the procedure.

User Avatar

They could if worn or warped to the safe and legal limit.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.