0
Should you keep the ignition switch in the lock or off position on a 1964 Impala to keep the battery from draining?
Either the off or the lock position will cease current to all but the most critical systems. Not many of those are on a 64' Impala. Maybe a clock. If your battery is draining there could be a short circuit somewhere. You'll nee to trace it out with a test light or multimeter. Start at the fuse block and try to find circuits that have power, but shouldn't. Good luck. Nice car. Well worth your time.
What else can I help you with?
Should I keep the ignition switch on lock or off on a 1964 Impala to keep the battery from draining?
Yes. Otherwise you will drain the battery through the ignition points, burning them out prematurely or even welding them together.
What drains battery on a 2000 Chevrolet impala with a good alternator?
Dead cell in the battery requiring a replacement battery or some light is on that is draining the battery. Can also be a stuck relay.
What is causing the heat in your 2005 Impala to run continously even with ignition off and draining my battery?
I just had this problem. It's the relay switch under the dash on the passangers side. It cost about 75 bucks for the part and anyone can do it. It's just 2 screws.
How do you reset the Low Tire Pressure display on a 2003 impala?
While the ignition is in the ON position, follow this sequence:Turn your headlights to the parking position and then OFF 3x's.
What electric problem would cause a 2008 Chevy Impala slow to crank?
It could be a weak battery or a bad ignition coil.
What causes a 2001 Chevy impala not to start unlpugged the battery and plugged it back in and it won't start?
bad ignition, bad battery, bad starter, need more info in the question
Your Chevy Impala is not starting sometimes When ignition is put into on position everything works the car just does not start Can anyone help with this?
Loose or corroded battery cables? Bad starter solenoid? Dead spot on starter? Bad neutral safety switch?
Where is the ignition fuse located in a 1985 Chevy Impala and which fuse is it?
The ignition is not fused.
How do you replace ignition switch on a 1966 Chevy impala ss?
The 1966 Chevy Impala ignition switch can be removed by loosening the retaining ring at the top of the ignition switch. Remove the wiring harness. Reverse the process to install the new ignition switch.
How do you remove the battery on a 2003 Impala?
To remove the battery on a 2003 Chevy Impala, first ensure the vehicle is turned off and the keys are removed from the ignition. Use a wrench to disconnect the negative terminal (black) first, followed by the positive terminal (red). Once both terminals are removed, unbolt the battery hold-down bracket and carefully lift the battery out of the tray. Always exercise caution, as batteries can be heavy and contain corrosive materials.
2002 impala ignition key hard to turn why?
it is either the key is worn out or the key cylinder in the ignition is worn out.
Can you use a 2002 ignition switch on a 2001 Chevy Impala?
YES.....
