0
What else can I help you with?
How do you remove the rear seat from a 1998 Sebring convertible?
# Slide your fingers underneath the bottom part of the seat from the front. # Pull up. Hard.
How do you remove serpentine belt from 1998 Toyota corolla?
Cut it and pull it off. Be sure to take a look at the installation of the belt before removing it. You will need to install the new in the same configuration. Tightening the belt can be tricky.
In a 1999 Chrysler Sebring Convertible the seat belts are stuck and will not pull out how can this be fixed?
I have the same problem in a 2000 Sebring. You can't pull the seat belts out of the seat's retractor. According to the owner's manual the seat belt mechanism needs power on to allow the seat belts to extend. When you open the door or put the key to accessory position power is allowed. The fuse for the seat belts is listed with the flashers and the flashers work ok. I will post more after I fix it. There is a wire connector under the seat that controls the seat belt mechanism. You have to make sure it is connected otherwise the seat belt will remain in the stuck position. I had the same problem, seat belt was stuck and I couldn't use it. I discovered the wire wasn't connected under the seat. Once I reconnected it and turned on the car I was able to pull the seat belt out.
How do you replace a fuse on a 2001 chrysler sebring?
Pull out old, insert new.
1998 mustang seat belt wont pull out?
Apparently there is a major problem with these seatbelt doing this. You'll probably need to replace the whole unit.
How do you change a belt on a 1998 Ford Explorer XLT?
Use a 3/4 inch pull bar or wrachet tool and take the pressure off the belt tensioner. Then just remove the belt and there should also be a diagram of how to do this on the inside of your engine compartment along the top of the grill somewhere.
How do you check the transmission fluid on your 2004 Sebring?
Start engine, idle in park. Pull dipstick, wipe off and reinsert. Pull dipstick and read the level.
How can I fix a 2004 Sebring seat belt that will not pull out when car is on a sharp grade?
Depending on how steep of a grade, it may be normal operation. The seat belts use a swinging weight in them to lock during an accident. If the grade is steep enough, the weight may be in the locked position.
How do you remove an alternator bracket on a 1998 Dodge Caravan 3.3 Liter engine?
remove belt, remove alternator plugs, then bolts. pull out alternator. then undo bolts for bracket and remove.
How do you change the serpentine belt on a Chevrolet s-10 1998?
It's pretty easy top cahnge a serpentine belt. There is a belt tensioner on the front of the engine. It should have a square hole in it for a 1/2 inch ratchet or breakover bar. using one of those tools, pull back on the spring loaded tensioner and you will get slack in the belt. Slip it off and replace it.
Can a cop pull you over just for not having seat belt on in Arizona?
A cop can pull you over for not having a seat belt or anything else. Under the Patriot Act, they don't need a reason to pull you over.
How do you install a serpentine belt on a 2004 Pontiac Montana?
The best way to change the belt is to cut the old belt in half and then use the old belt to pull up on the tension pulley it will slide on easily every time. (takes two people to do this one the pull and ond to slide the belt on.
