0
What else can I help you with?
Is Sony xplod good subs?
i got two sony xplod 12s and running off an 800 watt amp they sound good
How do you bridgd 4 channle sony xplod 500 watt amp?
To bridge a 4-channel Sony Xplod 500 watt amp, first ensure the amp is powered off. Connect the positive speaker wire from the left channel (positive) to the positive terminal of the subwoofer, and the negative speaker wire from the right channel (negative) to the negative terminal of the subwoofer. Set the amp's switch to 'bridged' mode, if available, and adjust the gain accordingly for optimal performance. Always consult the amp's manual for specific instructions and wiring diagrams.
You have 2 12 inch Sony xplod subs what kind of amp should you get?
probably 800 watts by 2 channels at least i had mine pushed by a 1200 watt sony xplod and they sounded great
What is remote wire for car amp?
remote wire is to control amp, bass coming from subs, and the frequency
Do you need to hook up the remote wire on your car amp?
Yes a remote wire is necessary. You must wire the remote wire from the amp to and ignition source of power (a component which turns on when the ignition in the car is engaged.) i.e. the radio. The remote wire signals for the amp to power on.
Where do you put the remote wire on your deck?
You only need the remote wire if you have an external amp.
Why doesn't your remote wire turn on your amp anymore?
Easy way to check were the problem is take a 6" piece of wire. Unhook the remote wire from your amp. Then hookup your 6" piece of wire to amp remote terminal then take other end and connect to the 12+ terminal. If amp powers up the its in the headunit. If amp does not powerup or goes into protect mode the amp is problem.
Which wire is a remote amp turn on wire on a 2012 dodge ram 1500?
The remote amp turn on a 2012 Dodge Ram 1500 is the wire that taps on the harness to supply the 12v.
What will happen if you connect your remote wire to the power wire of your amplifier?
Amp always on
What subwoofer would be best with a 340rms 800watt peak Sony xplod amp?
i would say the 1300watt 12" sony xplod sub i have one in my car and ive had a 600 peak power pushing it and it sounded good for the size and for only one sub. to much power will blow it id stick with the 1300 watt sub.
How do you bridge a Sony xplod 1000 watt amp?
To bridge a Sony Xplod 1000 watt amp, you will need to ensure it is capable of being bridged (most amps have a bridge mode). Then, take the positive output from one channel and connect it to the positive terminal of the speaker, and the negative output from the other channel to the negative terminal of the speaker. Finally, adjust the gain and crossover settings accordingly for optimal performance.
What do you do with the CD player remote wire?
The Remote wire is for the installation of an amplifier. When you install the amp, you have a power (+12V) and ground wire to power the amp, but if you did not have a remote wire, it would drain all of your battery power while you were away from the car (because it would continually suck energy from it); however, without the remote signal coming from the CD player, the amp does not turn on. Does that answer your question? Basically, unless you're installing an amp, don't mess with it.
