connect positive first then negative that is the safe way to do it
red or positive
Disconnect negative cable first from old battery and connect it last when installing new battery.
Remove the negative cable first and when installing the new battery connect the negative last.
Disconnect the negative cable first and connect the same negative terminal last when installing the new battery.
Remove - battery cable Remove + battery cable from battery and starter solenoid Route new cable following original routing Connect to starter solenoid Connect to + battery terminal Connect - battery cable
There are typically two cables, one is usually red and the other black. The black cable attaches to the negative terminal on the battery and the red wire connects to the positive terminal on the battery. When removing the battery from the vehicle always remove the negative cable from the battery first. When installing the new battery always connect the negative cable to the battery last.
Connect the Positive + battery cable to the positive + battery post first. Then connect the Negative - cable to the negative - battery post.
Always remember this rule. To take off_ Negatice first To put on, Positive first.(Red One)
No, the ground cable gets always disconnected first and connected last, regardless of ground polarity.
Disconnect the cable from the LeSabre battery. Follow the route of the cable and disconnect the other end. Pull the cable out, then fit the new cable in the same direction. Connect the non battery end, then connect to the battery.
Always connect the positive (RED) cable first.
Something is on drawing power from the battery. Always connect the positive cable first and the negative cable last.