The ABS light may indicate that the ABS system isn't working. The one in my van is coming on and going off from time to time. My mechanic says to wait until it is on all the time and he will replace the ABS module. The tire gauge light could mean that one or more of the tires have low pressure.
check the brake fluid level. try filling to top. Get it fixed !
In my experience I have noticed it comes on when I am low on brake fluid
you need a new brake pressure differential switch
In your gauge cluster there is a brake light which lights up if the emergency (parking) brake is engaged or if the brake fluid level in the brake master cylinder is low ( in your engine compartment) Also there is an ABS brake warning light that comes on if something is wrong with the ABS braking system - fuse , sensor , wiring connection etc. If it's anything more than releasing your parking brake , get it checked by a professional.
THERE IS A SENSOR ON THE FRONT AND REAR BRAKE PADS ITS TIME TO HAVE YOUR BRAKES SERVICED
Brake light, on your 2000 Chrysler Concorde, by accessing it from the inside of the trunk. Take hold of the brake light, push in and turn. The brake light will come out.
No, it is a brake light.
The red " BRAKE " warning light in your dash comes on if the emergency brake / parking brake is on , or if the BRAKE FLUID LEVEL in the brake master cylinder ( located in your engine compartment , near the firewall , on the drivers side of the engine compartment ) IS LOW
To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.
The brake light switch is on a bracket just above the brake pedal.
You can access the middle brake light from the inside of your 2000 Dodge Neon cargo compartment. Remove the brake light wiring harness. Remove the brake light retaining bolts. Reverse the process to install the new brake light.
The left brake light works the right brake light doesn't and the bulbs is good