0
How do you get your emergency brake light to go off after you release the brake on a 2000 Toyota Tacoma 4x4 I can push on the brake and the light goes off but when I let go the light comes on again.?
Wiki User
∙ 17y ago
you need a new brake pressure differential switch
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you release the emergency brake on an 2007 Nissan altima?
Press the pedal in again
What is the drive cycle to reset computer on 2004 Toyota tacoma?
If you are referring to when the computer again can monitor the systems after a manual reset, it is usually between 50 and 100 miles.
What time does the Tacoma mall open?
At 10am and closes at 9 Pm on sundays it opens at 11am and closes at 7pm
What does it mean when your check engine light on your 1999 Toyota Tacoma comes on for a couple of days and then goes off for a week and back on again?
You need it to pull out the code. It will allow you the find the reason. Without a particular it's almost impossible to find the problem.
What does a warning light that has an exclamation mark inside of perentaces with a squiggly line under it mean on a trailblazer?
If by perentaces you mean parentheses (or brackets) and not percentages then it means your emergency brake is on. To fix it just pull the emergency brake release handle and the pedal should come back again.
My 99 2.4 tacoma 2wd quit I tried to restart it and the battery lights and starter worked fine but wouldn't fire up I had it towed to the Toyota dealer and it ran fine the next day any suggestions?
I would replace the fuel filter and then see if it does it again. These type intermittent problems are hard to diagnose.
How do you get the tire down of the rack on a 2001 Toyota Tacoma truck?
Look by your rear license plate , there should be an access hole. You will need a portion of your stock lug wrench kit slide it in and turn it, it is a cam system and it will lower down. Warning dp not wind it back up with no tire on it , when you go to lower down again it will bind.
Brake light is on in a Toyota Tacoma?
AnswerIndicator light on dash? Check fluid level in master cylinderMake sure parking brake is fully releasedCheck Brake fluid levelI have a 1996 Tacoma 2.7L and my brake indicator light on the dash is always on. So- here's how to check what's wrong... Start truck, release parking brake, if light is on, push the parking brake handle in/towards dash, if light goes off then you have a bad spring (like my truck does) or the like on the parking brake handle. That's all. Sometimes when I drive, I push it in/light goes off and then the handle works it's way out again and the light comes back on.
Why would my 2008 Toyota Tacoma ac blower quit working then started again but very weak?
My wife's 2008 Tacoma blower motor stopped working at around $70,000 miles. If you kick the motor housing and it turns on/operates at normal speed, you will have to replace the blower motor. I got one from auto zone for about $100.00, that was 6 months ago. I have a new problem now. Mine is working on all of the settings, but is very weak. I am looking at the blower motor resistor, and trying to find out how to test it.
Is 2009 Toyota Corolla recommended?
yes because gas is raising up again
How do you reset your 1997 Toyota Corolla VIP alarm so it will start again?
ok
How do you release the emergency brake on a 88 jaguar xj6?
Push the button on the handle as you raise the handle. It will have to be pulled up firmly till you feel the cable release, then release the handle. Remember to keep the button down until the handle is all the way back down. You may have to do it again if someone has really pulled the cable up super tight!
