answersLogoWhite

0

The inhibitor switch tells the ECU that the (auto) transmission is in park P or nutral N and safe to start the montor so it isn't in gear, it also called the nutral safety switch ,it'slocated on the transmission.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is the starter inhibitor switch on a 1990 Volvo 240dl?

Where is the starter inhibitor swith on a volvo 1993 260 GLE i ?


Is there a fuse for the starter in a 1997 Mercury Villager?

Yes, there is a fuse in the fuse box, but it goes to the transmission inhibitor switch which provides ground to the inhibitor relay through the theft warning relay(if equipped). There is also a fusible link which provides power to the ignition switch. If the dash indicator lights come on then the link is probably alright. So, you could have a blown fuse, a faulty transmission inhibitor switch, a faulty theft warning relay, a bad inhibitor relay, or a bad starter motor.


Where is the starter inhibitor switch on a 1983 Volvo 240?

The starter inhibitor switch on a 1983 Volvo 240 is typically located on the transmission, near the gear selector. It is designed to prevent the engine from starting unless the transmission is in the "Park" or "Neutral" position. You may need to access it from underneath the vehicle for better visibility and reach.


How do you remove the inhibitor switch on a ef falcon?

how to remove inhibitor switch on ef falcon


On a 1991 caprice classic what would cause no power from the ignition to the starter solenoid?

check g/box inhibitor switch could be out of adjustment


What does inhibitor switch do?

Inhibitor switch reduces engine power to avoid shock while automatic transmission changing gears


Where is starter inhibitor switch on new holland ts 90?

The starter inhibitor switch on a New Holland TS90 tractor is typically located on the transmission housing. It is often mounted near the gear shift lever or on the side of the transmission assembly to prevent the engine from starting unless the transmission is in the neutral position. For precise location and troubleshooting, it's advisable to consult the operator's manual or service guide for your specific model.


What does an inhibitor switch do?

An inhibitor switch basically tells your vehicle whether its in motion or in park. It can tell the car to park or to go into first gear etc.


2002 Ba falcon auto trans inhibitor switch what does it do?

the inhibitor switch only allows the car to be started in Neutral or Park. No other positions.


Where is the clutch inhibitor switch located?

Its at the top of the clutch pedal there is a cruise control switch disengage switch at the bottom and the one above that is the clutch inhibitor switch.


1989 Chevy caprice I've changed the starterand fuel pump still wont crank?

run a jumper lead to starter crank connection pos feed if it crancks over check for power from ign switch in crank position on solonoid wire if no power check starter inhibitor switch for correct adjustment if ok check ign switch


How do you change inhibitor switch in holden vz ute?

To change the inhibitor switch in a Holden VZ Ute, first disconnect the battery to ensure safety. Remove the console cover and locate the inhibitor switch, which is typically found on the transmission. Unplug the wiring harness from the switch, unscrew it from its position, and replace it with the new switch. Finally, reassemble the console, reconnect the battery, and test the operation of the transmission.