Xylx® is a registered trademark used for Bolts of Metal and owned by NINGBO ZHENHAI XINGYI FASTENERS CO., LTD (ningboshi zhenhai xingyi jingujianzhizao youxian gongsi).
there should be a drain bolt on the lower front or rear section and a bolt on the top remove the top bolt and put the drain bolt on the bottom back in and fill the case from the top bolt untill fluid runs out and screw top bolt back in and hit the road
With out knowing what you are working on we can not help.
Not sure what you mean by back bolt ? There are 2 bolts holding the starter on. They both screw into the starter from the back. there is one on the bottom and accessed from underneath, and the one on the top is accessed from the top. Unhook the battery ground and remove the air box to gain access to the top bolt.
15mm socket will fit the bolt. Do you mean what is the length of the bolt? I mean the length of the bolt.
Yes, the long bolt (the gold colored one), goes on top
32 ft-lb. Start with TOP bolt on the port just RIGHT of center then go to the bottom bolt on that port. Next move to the BOTTOM bolt on the port just LEFT of center and then to the bolt on the top side of that port. Work your way out to the end ports this way torquing the TOP bolts on the RIGHT and then the bottom. And torquing the BOTTOM bolts on the LEFT and then the top bolt for that port.
the starter is located on top of the transimission. the top bolt is extremely hard to get to and the bottom bolt can be reached from the underside of the vehicle
usain bolt
Usain Bolt
A bolt for a girder is a bolt that is cast in place with the cap. Therefore the bolt is concreted into the cap of the substructure of the bridge. The girder is then set on top of bearing pads, on top of the cap, in between the girder bolts. The bolts are there to keep the ends of the girders from moving side to side.
take the breather filter off and look down at the transmissionthe top starter bolt is right there
It"s under the ghosts head and it"s a bolt that you screw in