passenger compartment fuse box #7 it is 20A fuse. center column, 3rd from the top.
Either the wiper arm slides on the axle, or the wiper motor died.
How to replace wiper motor on a 1998 montero sport mitsubishi
No, usually there is only one.
It controls the power to your wiper motor.
The Mitsubishi Eclipse has standard hook-end wiper arms on front and rear. See sources and related links below for installation videos.
To replace the wiper motor on a Mitsubishi Endeavor, first, disconnect the battery to ensure safety. Remove the wiper arms by loosening the nuts and gently pulling them off the shafts. Next, take off the interior cowl panel to access the wiper motor, which is usually secured by bolts. Disconnect the motor's wiring harness, remove the bolts, and install the new motor by securing it with bolts, reconnecting the wiring, and reassembling the cowl and wiper arms.
That depends on what you're calling the "control module". There is a switch that controls where the wiper blades "park". It's inside the wiper motor assembly. In fact, most of the controls, except the switch on the steering column, are inside the wiper motor.
ITS WITH THE WIPER MOTOR ITS ALL ONE UNIT
Starts at the reservoir pump and ends at the outlet.
The wiper motor is located on right rear of engine, hood up. Remove old wiper and replace before tightening the bolts test their location to mount.
The number six fuse controls the rear wiper motor in your 1998 Jeep Grand Cherokee. The number six fuse will be in the first column, fourth from the bottom.
The fuse for the windshield wiper on a 1999 Mitsubishi Eclipse is located in the fuse box under the dashboard on the driver's side. To access it, remove the cover of the fuse box and look for the fuse labeled "Wiper" or "Wipers." If the fuse is blown, replacing it should restore functionality to the windshield wipers. Always consult the owner's manual for specific fuse locations and ratings.