0
By connect a starter motor backwards I assume you mean put the negative cable where the positive cable would go and then put the positive cable to the negative connection. In that case the starter motor should run backwards. That might be a handy thing to do if you are using a starter motor to power something else such as a winch or maybe a pump.
What else can I help you with?
Installed a new motor in a truck but it turns over backwards and wont start why?
Is it a new starter motor? It may be incorrect.
Connect starter motor 1992 Ford Taurus 3.0?
That is a statement, - what is the question .
How do you take a transit connect starter motor off?
To remove the starter motor from a Ford Transit Connect, first disconnect the negative battery cable to prevent electrical shocks. Next, locate the starter motor, which is typically found near the transmission. Remove the mounting bolts securing the starter in place, and disconnect the electrical connections, including the power and signal wires. Once everything is detached, carefully pull the starter motor out of its housing.
What is the difference between a motor starter and a contactor?
Motor started will have overloads the contactor connect es line voltage.
1999 Chrysler Town and Country starter installation?
To install the starter, hold the starter motor spacer in position, install the starter motor-to-transaxle bell housing bolts, tighten it, and engage the solenoid wiring connector onto the terminal. Then, connect the B+ wire, tighten the retaining nut, lower the vehicle, connect the negative battery cable and verify starter motor operation. ÊÊ
What happens when a starter goes bad?
motor won't start.
What happens when a starter motor rotates at a high speed?
it burns
How do you wire dol starter?
To wire a Direct-On-Line (DOL) starter, first, connect the power supply lines (L1, L2, L3) to the input terminals of the starter. Then, connect the motor leads to the output terminals. Ensure that the overload relay is wired in series with the motor to protect against overcurrent. Finally, connect the control circuit, including the start and stop buttons, to the appropriate terminals on the starter.
How do you bypass the starter solenoid?
Remove the lighter gauge wires from the solenoid, and connect full battery power (cable) directly to to the positive post on the starter motor.
The magnets in motor were backwards?
the magnets in motor were backwards alls good thanks for the help
What is the Wiring diagram for connecting the starter solenoid to the battery on a 1993 ford tempo?
To connect the starter solenoid to the battery on a 1993 Ford Tempo, first, connect the positive terminal of the battery to the solenoid's battery terminal (usually marked with "B" or "+"). Then, connect the starter motor terminal (marked "S") on the solenoid to the starter motor. Additionally, ensure that the solenoid is grounded properly by connecting it to the vehicle’s chassis. Always refer to the vehicle's service manual for precise wiring details and safety precautions.
1972 Mustang won't start after the starter solenoid has been changed it doesn't click when the ignition is turned what could be wrong with it?
Solenoid could be installed incorrectly. Could be electrical connection on the solenoid. Did you re-connect the battery? Could be a bad starter motor...or a stuck starter motor. Sometimes a light tap or two on the starter motor (not the solenoid) with a hammer will free it up.
