0
What else can I help you with?
What is cutting roters?
Cutting rotors, often referred to in the context of automotive maintenance, involves machining the surface of brake rotors to restore their flatness and remove any imperfections or warping. This process helps improve braking performance and extends the lifespan of both the rotors and brake pads. Typically performed when rotors become worn or develop grooves, cutting rotors ensures even contact between the brake pads and the rotor surface. However, there are limits to how much material can be removed, so it's essential to assess the rotors' condition before deciding on this service.
Are cutting rotors required with pad changes?
Not usually required but recommended. If the surface of your rotors have any grooves or gouges, then yes definatly have them "turned" at a shop or replaced. If your brake pads are replaced regularly then you should be fine.
What should you have to pay for the putting on of new brakes on a 2004 sable No rotors to be recut?
It seems like mechanics always turn the rotors no matter what because they don't want to take the time to do the measurements to see if the rotor is in good condition. If they were to take the measurements they could extend the useful life of the rotor. So, if the car is taken to a shop they are going to cut the rotors and turn the drums and give a $200 estimate. The only way to avoid cutting the rotors is to do it yourself.
What is the grinding noise coming from the rear of your Honda Pilot?
If it happens right when you are stopping or coming to a slow stop, it is probably your discs cutting into your rear rotors. You need to get them replaced ASAP.
Can cutting the brake rotors on a 1999 E-250 Ford van and installing new brake pads cause a rupture to the brake line?
No, The brake line will rupture from excessive rust and heavy to moderate braking. If the rubber line running to the caliper is old and dry rotted then that may also blow out. as for cutting rotors and installing pads, that will not affect anything with the brake lines unless the caliper was not suspended correctly during replacement of rotors. the caliper must be held with a piece of wire to keep tension off of the rubber brake line. allowing the caliper to hang from that line can damage it.
How many rotors on a 2001 Chevy Cavalier?
25 rotors. Cavaliers have 25 rotors on the car.
Why would the front rotors turn after changing the brake pads and rotors?
Possible wrong rotors???
Is there a special rotor for the 2001 Sport Trac brakes?
no nothing special, your typical rotors will do. no nothing special, your typical rotors will do. no nothing special, your typical rotors will do. no nothing special, your typical rotors will do. no nothing special, your typical rotors will do.
Do you need to grind the rotors when placing new brake pads?
If the rotors are in good condition, not warped, not scratched, then you can replace the pads without turning the rotors. Inspect the rotors carefully.
Brakes make a grinding noise?
Sounds like the brake pads - shoes are worn down to medal and cutting into the rotors and drums. Need to pull all 4 wheels off and check the brakes.
Do you do a wheel alignment before or after changing rotors?
after changing rotors
What is reciprocating rotors?
A reciprocating engine is different than when using rotors. Rotors are used in a pistonless rotary engine, using one or more rotors and sometimes called rotary pistons.
