answersLogoWhite

0

1and 1 4

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you put a carburetor on a PW80 back to factory setting?

Not shure


Setting the carburetor to factory settings on the baja heat mini bike?

The black Phillips head screw on the rear of the carburetor adjusts the airflow. You need to have it about 4 full turns into the hole and that's factory. To set the carburetor, just continue to screw in the air screw until the bike runs properly. In your climate, you will hear and feel the bike get smoother as the carburetor gets to the proper setting. Try it out and have a blast!!


What are carburetor setting for a 18 inch searcraftsman chainsaw?

try 1 1/4 turns and work from there.


What is the timing setting for a Chevrolet Small-Block carburetor?

You don't set timing on a carburator or are you asking the timing on the motor


How is the carburetor to be adjusted on a 1997 Yamaha blaster?

i need to know what the factory setting is for the fuel air mixture on a 1995 Yamaha blaster.


What is the setting for a Carburetor kawasaki 650sx jet ski?

You have to open the carb dissamble evrything go into the combustion chamber and put oil


What are the carburetor settings on a 1991 Yamaha Phazer ll?

The only setting is one screw on the top of each carb its the mixture screw and should is 1.5 turns out by default.


What is sensor carburetor and electronic carburetor?

The sensor carburetor uses the sensors in its operation while the electric carburetor uses the electric current in its operation.


What is the float setting on a 10hp Briggs and stratton 300421013701?

The float setting on a Briggs & Stratton 10hp engine, specifically the model 300421013701, is typically adjusted to maintain the correct fuel level in the carburetor bowl. For this model, the float height should generally be set to about 1/8 inch from the gasket surface when the float is in the closed position. It's important to consult the specific service manual for precise measurements and details for your engine, as variations may exist based on the carburetor model. Always ensure the carburetor is clean and properly assembled before making adjustments.


Where is the idle setting on poulan pro 4218avx?

The idle setting on the Poulan Pro 4218AVX chainsaw is typically adjusted using the carburetor's idle screw, usually marked as "T" for throttle. To locate it, you may need to remove the air filter cover to access the carburetor. Turn the idle screw clockwise to increase idle speed and counterclockwise to decrease it, making small adjustments while the saw is running to find the optimal setting. Always consult the user manual for specific instructions and safety precautions.


Honda shadow carburetor adjustment?

The Honda Shadow carburettor adjustment will be done through the setting of the pilot screws.You would also need to do synchronization so as to compete the adjustment.Ê


Why Briggs and Stratton 6.5 hp starts but cuts off?

Three things you want to look for: dirty/clogged ful filter; faulty spark plug; carburetor setting.